ABCDEFG
1
Last Revised: 10/29/22 These features are not currently possible: operating cameras/spot light/ACC at any speed
2
** Below: ignore whatever you have where the x's are and just write the non-x value in the correct position ** Note: module BCM=BdyCM in FORScan
3
Feature NameModuleAddressValue changeNotes
4
Auto Start/Stop Disable - by disabling BMS (Battery Management System)BCM726-48-02x0xxxxxxxxxx
5
FCIM7A7-01-01xxxxx0xxxxxx(optional - disables switch)
6
IPC720-01-01xxxx1xxxxxxx(optional - disables stop/start message center in the trip/fuel IPC menu)
7
DRL - Position Lamp CfgBCM726-29-02x1xxxxxxxxxxposition lamps at full brightness like Super Duty
8
DRL - Parking Lights only (stock LEDs only)BCM726-26-02x1xxxxxxxxxx** Testing DRLs: Make sure all of the following are set: **

1. Daytime Lights box checked in cluster under settings, adv settings, vehicle, lighting
2. Headlamp switch in the Auto position
3. Truck must be in gear for DRLs to work
9
726-50-0101xx
10
DRL - Parking Light only (Halogens)BCM726-26-02x1xxxxxxxxxx
11
726-45-01xxxx7Fxxxxxx
12
726-50-01108E
13
DRL - Parking Lights & Low Beams onlyBCM726-26-02x1xxxxxxxxxx
14
726-50-0102xx
15
DRL - Parking Lights & Turns onlyBCM726-45-01xxxx7Fxxxxxx
16
726-26-02x1xxxxxxxxxx
17
726-50-0108xx
18
DRL - Anzo switchback white haloBCM726-45-01xxxx7Fxxxxxx
19
726-26-02x1xxxxxxxxxx
20
726-50-0110xx
21
DRL - Turns only (Halogen/aftermarket lights only)BCM726-45-01xxxx7Fxxxxxx** On stock LEDs this will also illuminate outer halo
22
726-50-0108xx
23
DRL - Front Fog Lights onlyBCM726-45-01xxxx7FxxxxxxTo enable DRL Parking Lights with these set 726-26-02: x1xx xxxx xxxx also
24
726-50-0104xx
25
DRL - High beams onlyBCM726-45-01xxxx7Fxxxxxx
26
726-50-0120xx
27
Powerfold Mirrors (trucks without memory buttons)DDM740-03-01*xxxxx0=disabled, 8=enabled
28
PDM741-03-01*xxxxx
29
** click here for tmcolegr's post on retrofitting non-folding to folding mirrors
30
Autofold MirrorsDDM740-03-01x8xxxx** Tow mirrors require swapping pin 18 & 19 on mirror connector (see posts linked below) **
31
DDM740-12-01FxxxTow Mirror mod instructions
32
PDM741-03-01x8xxxxB-ManFX4's comprehensive write-up w/pics on tow mirror mod here
33
PDM741-12-01Fxxxregular autofold vs Lincoln autofold explained
34
Autofold Mirrors - Lincoln Style (see desc in Notes)DDM740-03-01x84xxx** Tow mirrors require swapping pin 18 & 19 on mirror connector (see posts linked above) **
35
DDM740-12-01Fxxxregular autofold vs Lincoln autofold explained
36
PDM741-03-01x84xxx
37
PDM741-12-01Fxxx
38
Reverse Tilt MirrorsDDM740-03-01Fxxxxx** Note: this only works for mirrors with memory **
39
DDM740-13-01FxxxSelect left/right mirror, put truck in Reverse and mirror will automatically tilt down toward curb and then return to normal position when gear is changed.
40
PDM741-03-01FxxxxxFollow this link for the proper adjustment procedure for this mod
41
PDM741-13-01Fxxx** For a 2018 740/741-13-01 may require FCxx **
42
43
Global Window Open/CloseBCM726-17-0101010101014AAfter pressing lock/unlock on fob, press lock/unlock again and hold button for front windows to go up/down
44
BCM726-17-0201010101014B
45
BCM726-30-010101xxxxxxxx
46
DDM740-05-01Dxxxxx
47
PDM741-05-01Dxxxxx
48
Disabling Canadian forced DRLs to cluster controlledBCM726-16-0201010101014ADRL Cluster Control 1 enabled
49
BCM726-21-01xxxxxxxxx1xx
50
IPC720-02-01xxExxxxxxxxxDaytime Lights option & Lane Keeping System present in Settings
51
OR
52
IPC720-02-01xxCxxxxxxxxxDaytime Lights option present & Lane Keeping System absent in Settings
53
Double Horn Honk disableBCM726-41-02xxx0xxxxxxxx
54
Auto Relock enable (2015-2016s)BCM726-15-02010101010149If truck unlocked with fob, truck auto relocks after 45 seconds
55
Auto Relock enable (2017-present)BCM726-15-02010101010149
56
BCM726-21-01xxxxx1xxxxxx
57
BCM726-38-02xxxxxxx*xxxxAuto Relock Time Duration: 1=30 seconds, 2=45 seconds
58
Allows NAV & ability to read text messages while vehicle in motionAPIM7D0-02-015753xxxxxxxxSync2 - Sirius Travel Link no longer works
59
Sync3 - 911 assist will be disabled with this enabled. Speed limit sign will look European and FM radio stations will have and extra number like 102.70 instead of 102.7
60
Ability to do fogs & high beams at same time
aka "Bambi mode"
BCM726-27-01xxxxxxx0xxxxBambi mode without high beam/fogs remembered after ignition off/on
61
BCM726-27-01xxxxxxx001xxBambi mode with high beam/fogs remembered after ignition off/on
62
Driver seatbelt minder status offIPC720-01-01xxxxxx2xxxxx
63
Passenger seatbelt minder status offIPC720-01-01xxxxxx4xxxxx
64
Driver & passenger seatbelt minder status offIPC720-01-01xxxxxx0xxxxx
65
Disables Door Ajar warning chimeIPC720-01-02xx0xxxxx
66
Engine temp & Transmission temp shows above gauges (8" Clusters only)IPC720-07-01xxxxxE5xxxxx** use this if you have trailer brake controller and turbos **
67
IPC720-07-01xxxxx65xxxxx** use this if you don't have trailer brake controller but have turbos **
68
IPC720-07-01xxxxxA5xxxxx** use this if you have TBC but don't have turbos **
69
IPC720-07-01xxxxx25xxxxx** use this if you don't have TBC or turbos **
70
IPC Quick Boot (No Ford animation shows on cluster)IPC720-07-01xxxxxxxx2xxx
71
Enables stereo to be turned on without Accessories on (2015 F150s only)APIM7D0-01-01xx2xxxxxxxxx2016 Models already have this capability
72
Fake engine noise disableACM727-01-01xxxxx0xxxxxx
73
DSP783-01-01Exxxxxxx<---2018 Lariat+ models may require this also
74
Heated & Cooled Seat Icons on home & climate screenAPIM7D0-01-01xxxxxxxxx2xx** use this for Sync 3 **
75
APIM7D0-01-01xxxxxxxxA6xx** use this for Sync 2, also enable Climate Quadrant for this **
76
Heated & Cooled Seat Icons AND Heated Steering Wheel on home & climate screenAPIM7D0-01-01xxxxxxxxx6xx** use this for Sync 3 **
77
Climate Quadrant enabled (only Sync 2)APIM7D0-04-01xxxxxxx0xxxx
78
Powerpoint timeout disabledBCM726-39-011194x0xxxxxxClick here for a hardware mod that achieves the same thing
79
Powerpoint timeout enabled & set to 1 secondBCM726-39-010001x1xxxxxxuse DeltaNu1142's powerpoint timeout calculator here **
80
81
Hill Descent Control enabled (2015-2017s)ABS760-03-01x*xxxx
82
If you have 0 for asterisk make it 2, if 4 make it 6, if 8 make A, if C make E, if 1 make it a 3** also need this switch **
83
youtube video showing removing front cover to access switch
84
Hill Descent Control enabled (2018-2020s)ABS760-03-01*xxxxxif your as-built is 0, use 2, if as-built is 1, use 3. if as-built is D, use F. If as-built is 5, use 7. If as-built is 4, use 6
85
Trailer Brake Control Module enabledIPC720-07-01xxxxx*xxxxxxif your as-built is 0, use 8. if your as-built is 6, use E
86
Trailer Brake Controller Gain Setting enabledIPC720-04-01xx4xxxxxxxxx
87
Perpendicular Park enablePAM736-04-01x2xxxxxx** only for trucks that already have Active Park Assist **
88
Secure Idle enableBCM726-42-01x1xxxxxxxxxxif engine is running but fob is away from vehicle, vehicle cannot be put into any gear
89
Panic AlarmBCM726-37-01xxxxxxx0xxxxPanic alarm on fob disabled
90
BCM726-37-01xxxxxxx1xxxxPanic alarm on fob requires 2 presses
91
BCM726-37-01xxxxxxx2xxxxPanic alarm on fob enabled
92
Panic AlarmBCM726-01-02xxx0xxxxxxxxPanic alarm - lights & horn
93
BCM726-01-02xxx1xxxxxxxxPanic alarm - lights only
94
Adding Climate menu on Sync (XL/XLTs)APIM7D0-01-01xxxxxxx3xxxxThe following won't work on XLT w/climate: Max A/C, Auto mode, Temp (numerical) settings, Fan speed, Max Defrost
95
7D0-01-02xxxxx2xxxxxx
96
Auxiliary External SubwooferACM727-01-01xxx8xxxxxxxx** use this for aftermarket kicker sub & amp **
97
Sync 3 New Blue Theme - GT Performance boot animation - doesn't work on Sync 3 v3.4APIM7D0-01-020xxxxxxxxxxx
98
7D0-02-01xxxxxDxxxxxx
99
7D0-03-01xxxxx4xxxxxx
100
Variable Line Level Preamp Outputs From ACM (for adding aftermarket amp without sound clipping)ACM727-01-01xx5AxxxxxxxxSee DanMc85's post here for a write-up on this