A | B | C | D | E | |
---|---|---|---|---|---|

1 | |||||

2 | Input your stepper and driver settings here | ||||

3 | |||||

4 | Stepper motor degrees per step | 1.8 | |||

5 | Steps per 1 revolution | 200 | |||

6 | Microsteps set on driver | 10 | |||

7 | Steps per revolution with Microstepping | 2000 | |||

8 | Gear Ratio. If it is 100:1, type 100 | 100 | |||

9 | |||||

10 | Mach 3 Settings | ||||

11 | Steps Per Degree | 555.5555556 | This setting in Mach 3, under Motor Tuning is described as steps per inch. Entering this calculated number is changing that to steps per degree. | ||

12 | |||||

13 | |||||

14 | Steps Per One Revolution | 200000 | |||

15 | Steps Per Min to Achieve | 6366197.724 | How many steps per minute are needed to get the desired speed | ||

16 | |||||

17 | Velocity Calculations | ||||

18 | Desired Feed Speed | 100 | Inches/mm per minute | ||

19 | Part Diameter | 1 | inches/mm | ||

20 | Circumference | 3.141592654 | Calculated Circumference | ||

21 | Revolutions Per Minute | 31.83098862 | Calculated Revolutions needed for desired speed | ||

22 | Degrees Per Min Needed | 11459.1559 | |||

23 | Small Part Deg Per Min | 22918.31181 | Calculate highest speed for smallest diameter | ||

24 | |||||

25 | Trial and Error Acceleration | ||||

26 | Desired Acceleration | 1000 | Increasing speed by second/ each second | ||

27 | Full Speed Achieved After | 0.3819718634 | Seconds | ||

28 | |||||

29 | Mach 3 Motor Tuning Entries | ||||

30 | |||||

31 | Steps Per Degree | 555.5555556 | |||

32 | Velocity | 22918.31181 | |||

33 | Acceleration | 1000 | |||

34 |

Loading...