WorkerBurn Differences
 Share
The version of the browser you are using is no longer supported. Please upgrade to a supported browser.Dismiss

View only
 
ABCDEFGHIJKLMNOPQRSTUVWXYZ
1
A Part NameSameODIDLengthIssues
2
AFGYes
3
BackButtNo
Spring Guide is a Delrin Rod, and much too short which causes the prime to feel crunchy
4
BarrelNo0.6250.51413.75
Counterbored to .555" at one end for the o-ring on the ramrod tip. NOT compatible with accufakes
5
Base ForegripYes
6
Bolt ArmsNo.118" thick
Through-holes instead of tapped, too thick to fit magwell upper loosely. Use of hex nuts for attachment makes this hardware set incompatible with the Railgasm set.
7
ButtplateNO
Really complicates removal of the BackButt for spring swaps. Newer file of this and FrontButt make the process much easier
8
Extension SpringsNo
Notably weaker
9
FrontButtYes*
Older revision that lacks the hex socket. Which the hex nuts they include wouldn't fit anyway.
10
GripYes
11
Hex NutsNo5/16"
Very loose thread fit. Too small to utilize the hex slots in the printed parts
12
Magwell LowerYes
13
Magwell UpperNo
Upper and Coupler Merged. Holes for the threaded rods don't bottom out, which makes assembly of the front half annoying.
14
MuzzleYES*
Older revision that uses screws to hold barrel. Newer version acts as a clamp and provide a better hold.
15
Muzzle BrakeYes
16
PlungerYes
Being printed the wrong way around
17
Plunger tubeYesIdentical
18
Ramrod BaseNO.510"
Older revision. ID larger to suit Ramrod. NOT COMPATIBLE with standard Caliburn ramrod cores.
19
Ramrod CoreNO.510".354"4.75
It's an inch shorter and will not fit in the standard Caliburn barrel. Also performs TERRIBLY if the o-ring escapes. And the lack of takedown functionality means that putting the o-ring back on is nearly impossible.
20
ScrewsNO
Annoyingly there are 4 different ones instead of just two
21
ShockpadNo
Not adhesive-backed. Thicker
22
Short PinsNo
Notably shorter. Include knurling on one end that makes them slightly captive once installed, but that makes them orientation sensitive as a result.
23
Spacer TubingYes*
8mm OD x 6mm ID Carbon fiber tubing which I've used a few times before. It's just miserable stuff to cut.
24
StandoffNo0.2750.294
Component was modified to fit part as printed
25
Stock SpacerYes?
Printed Part instead of cut from tubing
26
Stock_KiriYes
27
Takedown PinsNo0.1832"
OD of part was reduced slightly to match the dimensions that result on the prints. Parts are completely pointless and do nothing with the merged upper/coupler.
28
Threaded RodsYes
Slightly shorter, but thread spec if fine.
29
Thumbhole StockNo
Made the tubing hole a through-hole
30
TrenchYes
31
32
33
34
35
36
37
38
39
40
41
42
43
44
45
46
47
48
49
50
51
52
53
54
55
56
57
58
59
60
61
62
63
64
65
66
67
68
69
70
71
72
73
74
75
76
77
78
79
80
81
82
83
84
85
86
87
88
89
90
91
92
93
94
95
96
97
98
99
100
Loading...