ABCDEFGHIJKLMNOPQRSTUVWXYZAA
1
Date ReportedBoat/EquipmentIssueMore DetailContactContact phone/mailFixed DateOther
2
5/2/19Virtuoustracks in stroke seatwing nuts are not the right size so do not fullly tighten. In result, the tracks tend to move toward stern during the row, so the seat will hit the back of the tracks.Eileen Normoyle215-651-154305 02 19
Wing nuts are the corect size.
3
5/16/19Knechtshoes & spacer Stroke shoes need heel tie downs plz; need a spacer for 3 seat's starboard rigger (couldn't find a spare that would fit); bow shoes are falling apart and replacements would be lovely Dana Andersdanders07@yahoo.com (609) 792-4609
tie down and spacer 5/16
4
5/16/19DeFrantzno bow ballnoticed this while putting Knecht away this AMDana Anders5/19/19
5
5/21/19KnechtSteering is non-response / doesn’t workCables loose; need new shoes; rudder doesn’t have full range of motion
Alix / Dana / Jenn
5/22/19
6
5/25Blanche
Stroke seat wheels stick. Also tracks quite pitted, mini craters
Stroke seat sticks abruptly and makes high pitched noise. It’s intermittent and unpredictable. ? Wheel bearing, because not a consistent place on slide Tom Simon
tjs.vbc.house@gmail.com 610 716 7815
replaced six of eight wheels RJ 5/25/19
7
6/4Blanche Stroke seat slide seized upSame problem as before. Seems likely to be tracks, because wheel replacement didn’t cure it . Thanks for attending to this. (will spare you squeaky wheel jokes)Tom Simon
tjs.vbc.house@gmail.com 610 716 7815
RJ 6/6 New seat
8
6/12/19Voluminous Lost skeg Handwritten Do not row note on oarlock.Luke Rein6/13/19
9
‘6/1327xl ‘V8’Foot Stretcher Bottom not attached. Boat not tied to rack.Placed boat on slings to inspect. Cover was not properly attached. Stretcher bottom bolt was fully tight (very) and not in the track. The top track bolts were loose. East fix, but whoever put it away should not have done that in that way. Eric Eckstein
Eric.alan.eckstein@gmail.com
6/13/19
10
6/26/19USANeeds port covers- all are covered with duct tape-. Also, stroke seat tracks are pitted and should be replaced
11
7/3/1927xl 'v8'Seat missing. Boat filthyFound seat missing. Borrowed seat from 1x top rack (returned when done). Cockpit was brown with dirt . Washed boat completely when done.Eric Eckstein
Eric.alan.eckstein@gmail.com
7/3/19
12
7/3/2019Chomp 1xSkeg went bye byeSubmerged log, took skeg offHelen Eisenach helen@eisenach.org7/8/19
13
7/4/1927xl 'v8'starboard (left hand) backstay hull side nutleft backstay bolt came out during row. Bolt still presnt so replaced and gently rowed back. Peter reviewwed and we replaced the nut/washer and retightened all bolts on the boat. Appears to be good to row. Eric Eckstein
Eric.alan.eckstein@gmail.com
7/4/19
14
07/09/19Matrix 27x on V5 rackSeat MIACould not locate the missing seat for this boat; The starboard side porthole cover for the access point to adjust the slide wingnut is also missing. Placed the "Do Not Row" hang tag on the oarlock. Dana Andersdanders07@yahoo.com7/12/19
15
7/9/19LenariSkeg knocked offLibby Hughes7/10/19
16
7/9/19V3(?)Skeg knocked offSkeg knocked off. Has a Do Not Row tag on itLindsey Healy7/15/19
17
7/13/19KnechtSteering cable inopTwo strokes after we launched a CLR, steering cable snapped inside black rubber cable tube (starboard side). It’s rigged and back on rack with Do Not Row tag.
Dana/Marilyn/Eileen/Marsha
7/15/19
18
7/16/19Virtuous 2xmissing nuts for screws (.04 mm?) that attach footstretcher tracksFootstretcher assembly is noticeably loose when rowing
Catherine Reddick
19
7/21/2019Blanche 2xPort side shoe on bow stretcher is detached from stretcher7/22/19
20
7/25/19Blanche 2xThere is a small (what looks like) hairline crack in the bow on port sideErika McCormick
assume this is fixed?
21
7/26/19Matrix 27xlStarboard side stretcher track broken (teeth)Teeth broke during piece. Boat tagged DNR. Peter looked at and suggested turning teeth track fore/aft to allow to row until replacement available. Eric Eckstein
Eric.alan.eckstein@gmail.com
8/2/19
22
8/1/19Voluminous 2xAfter this morning’s row, Nick noticed a small crack in the stroke’s port side back stayNick feels it’s rowable, but it does need to be replacedEric Eckstein
Eric.alan.eckstein@gmail.com
assume this is fixed?
Eric ordering backstay
23
8/7/19Voluminous 2xThe carbon footwell in bow seat is eroding, exposing the honeycomb laminnate.If left unadressed, water could sit inside the layered laminate and further damage the material.Garrett O'Brien
g.thomasobrien@gmail.com
assume this is fixed?
24
8/8/2019DeFrantzNo Bow Ball, steering cable on toe is frayed. Only one wire attached at toe. Shoes at stroke seat need to be replaced K. Papandrew Kaypap@aol.comfixed
25
8/8/2019DeFrantzit also has a footstretcher track that is loose, right bowAnne Dinshah
annedinshah@hotmail.com
fixed
26
8/13/2019BlancheStroke seat wheel is broken - bearings falling out. All wheels and tracks need to be replaced. Seat was left on the back equipment area as it is not towable. Also stroke starboard rigger was making a lot of metallic pinging. Could not determine the cause but the par lock should and mounting should be checked.Shannon kaplanSyottkaplan@gmail.com8/14/19Back in service. Replaced the tracks. The bolt holding the wheel was stripped so I replaced the seat. Took the oarlock, etc., apart and found nothing amiss. Maybe I fixed it doing that.
27
8/22/19M27 on rack V5Sawtooth channel of footstretcher broken offAn inch or so of the stern most part of both sawtooth channels of the foostretcher tracks (toe area section) are broken off. It doesn't affect my useage since I do not lock the footstretcher that far to stern. Dana Andersdanders07@yahoo.comfixed
28
8/24/2019Virtuous 3cm circular indentation, ~70 cm from stern, port sideNoticed before rowing, shown to captain. Clear coat, hull, and paint intact. Not sure if action necessary . Tom Simontjsimon2@gmail.comfixed
29
8/28/2019single on rack V5no fintook boat off rack and noticed fin was loose it is now off of boat, boat can't be rowedJim McGlonejsm196167@gmail.comfixed
30
8/28/2019single on rack V6no finfin ripped off after pushing away from dock, boat can't be rowedJim McGlonejsm196167@gmail.comfixed
31
8/29/19Matrix 27xl (v8)no skegtook boat off rack and no skeg. Also appears that the Matrix27 has no skeg( could be what Jim is referring to as v5 and v6 above)eric Eckstein
Eric.alan.eckstein@gmail.com
fixed
32
9/3/2019
aqua thruster (bubbler)
bracket is broken that is used for suspending the unit in the waterbracket broke off of the aqua thruster when we went to move it after seeing it stuck in the mudJim McGlonejsm196167@gmail.com
33
9/11/19Blanchecracks in bowboat hit submerged log mid river at 3 Angels. Maybe rowable with duct tape patch until repairs can be made.Matt Kremermkremer01@gmail.comfixed
34
9/24/2019Vengeful 3-4 mm dent in bow deck, starboard sideDiscovered while wiping boat after row. We did not contact any solid object, so no explanation. Pointed out damage to Jen Mussio. tjsimon2@gmail.comfixed
35
10/10/19KnechtNeed to replace some of the bolts that are stripped, not sitting flush and have metal pieces sticking outChecking with GKaplan on spare bolts. Once I find them, I'll replace them on Saturday between racesDana Andersdanders07@yahoo.comfixed
36
10/13/1927xlDeep Scratch fixed
37
Deep scrarch about 2’ from stern Sent email to JennEric Eckstein
Eric.alan.eckstein@gmail.com
fixed
38
10/22/19Lenare rudder slightly bentThe rudder is slightly bent and brushing up against the skeg; Was rowable but felt a little "off" while steeringDana Andersdanders07@yahoo.comfixed
39
10/24/2019Virtuous Port bow backstay bolt missing bushingBolt lost after HOCR. Replaced with bolt obtained from Peter, but no Bushing available. Update: replaced with original bolt and bushing problem solved Tom Simontjsimon2@gmail.com
10/24/2019, 8 am
40
10/25/2019BlancheSmall hull puncture, starboard side, at bow seat. Will cover with duct tape for temporary fix to prevent water entry.Matt Kremerfixed
41
11/5/2019Hooten2 seat, port side backstay bent is bentHit a partially submerged log during practice. Not badly damaged. Eileen Normoylenormoylee@gmail.com
42
12/8/2019Molly HornA stick got caught on the skeg and knocked it off.Skeg lost.Marsha ZislingCell 484.558.7044
43
12/21/2019New quad 70 kgWe observed that the port side rigger in 3seat is bent . We didn't do it, just reporting it Eileen WalshNormoylee@gmail.com
44
12/31/2019Molly HornWe adjusted the toe steering to be straight when toe is aligned. Should be correct, but just alerting that it was adjusted. Thank you for moving toe to bow!Alix Jamesalixjk@gmail.com12/31/2019
45
1/5 USA 2xRigging is still off, boat is steering towards port
Chloe lewis/Helen Eisenach
46
1/28 VirtuousStroke seat right shoe is missing hardware and about to come off the foot plate. The tracks are consistently loose and even after we tiighten the wing nuts they will be loose again after a few rows Eileen/marsha2156510543
47
2/5Hornmissing port hole cover Eileen Walshnormoylee@gmail.com
48
3/6/2020Virtuous Stroke seat right show is coming loose and the metal foot plate is missing the middle nut at the mounting point to the foot stretcherShannon Kaplansyottkaplan@gmail.com
49
3/6/2020VIrtuous Tracks need to be replaced (probably wheels too) - feels like rowing on a rocky beach)Shannon Kaplansyottkaplan@gmail.com
50
3/6/2020VIrtuous Bow seat foot strecher mounting to boat (grooved tracks) are loose and need to be tighted downShannon Kaplansyottkaplan@gmail.com
51
3/6/2020VengefulBow seat foot strecher mounting to boat (grooved tracks) are so loose that they are going to need a larger screw to fix the issue. They move about 1/4" each strokeShannon Kaplansyottkaplan@gmail.com
52
53
54
55
56
57
58
59
60
61
62
63
64
65
66
67
68
69
70
71
72
73
74
75
76
77
78
79
80
81
82
83
84
85
86
87
88
89
90
91
92
93
94
95
96
97
98
99
100