ApplyLabWorkPeopolyMoaiSettings.xlsx

	A	D
1	Peopoly Moai Settings For ApplyLabWork Model Resin
2
3	Adjust the following machine settings for Modeling beige and black in the settings menu on the Moai:
4	(this was found to help with build plate adhesion, failed supports, and layer lines)
5	The following settings are for a stock out of the box Peopoly Moai. Details improved when heating
6	the build chamber to 30 degrees celsius and using the same settings.
7
8	Setting	Value
9	Z Moto Speed	5
10	PM moto speed	20
11	Z Follows	20
12
13
14	Modeling Beige Cura Settings
15
16	100 Micron Settings:
17	Setting	Value
18	Layer height	0.1
19	Initial Layer height	0.1
20	Bottom Layers	2
21	Infill Density	70
22	Print speed	50mm/s
23	Initial Layer speed	3mm/s
24	Number of slower layers	5
25	Laser Power (in LCD menu)	54
26
27	50 Micron Settings:
28	Setting	Value
29	Layer height	0.05
30	Initial Layer height	0.1
31	Bottom Layers	2
32	Infill Density	70
33	Print speed	140mm/s
34	Initial Layer speed	3
35	Number of slower layers	5
36	Laser Power (in LCD menu)	54
37
38	25 Micron Settings:
39	(Use at your own risk. About a 25% failure rate adhering to build plate. Very good results when it works.)
40	The settings worked significantly better when used with a heater.)
41	Setting	Value
42	Layer height	0.025
43	Initial Layer height	0.1
44	Bottom Layers	4
45	Infill Density	70
46	Print speed	180m/s
47	Initial Layer speed	3
48	Number of slower layers	5
49	Laser Power (in LCD menu)	53
50
51	Modeling Black Cura Settings
52
53	100 Micron Settings:
54	Setting	Value
55	Layer height	0.1
56	Initial Layer height	0.1
57	Bottom Layers	2
58	Infill Density	70
59	Print speed	75mm/s
60	Initial Layer speed	3mm/s
61	Number of slower layers	5
62	Laser Power (in LCD menu)	57
63
64	50 Micron Settings:
65	Setting	Value
66	Layer height	0.05
67	Initial Layer height	0.1
68	Bottom Layers	4
69	Infill Density	70
70	Print speed	130mm/s
71	Initial Layer speed	3mm/s
72	Number of slower layers	5
73	Laser Power (in LCD menu)	57
74
75	25 Micron Settings:
76	Setting	Value
77	Layer height	0.025
78	Initial Layer height	0.1
79	Bottom Layers	8
80	Infill Density	70
81	Print speed	180mm/s
82	Initial Layer speed	3mm/s
83	Number of slower layers	5
84	Laser Power (in LCD menu)	57
85
86
87
88
89
90
91
92
93
94
95
96
97
98
99
100