PID Pump Reference Guide Rev G.xlsx

	A	B	C	D	E	F	G
1	C100 PID & Pump Parameter Settings
2	Group	No	Description	Default	Setting Options	Recommended Setting	Notes
3	H	49	PID Select	0	0-1	1 (Enable)	This enables PID control so set to 1
4	H	50	PID F/B Select	0	0-Terminal A1 (0~20mA)	Depends on the system requirement	Selects which terminal PID Feedback is coming from
5					1-Terminal A1 (0-10VDC)
6					2-RS-485 Communication
7	H	57	PID Reference Selection	0	0-4	Typically left at 0 (keypad)	Selects where PID reference is coming from
8	H	58	PID Unit Selection	0	0-1	1 (% Units)	Selects how PID units will be displayed % or Hz
9	H	61	Sleep Delay Time	60s	0-2000	Usually less than 5 seconds	Amount of time waits at sleep frequency to go to sleep
10	H	62	Sleep Frequency	0Hz	0-max Hz	Depends on the system requirement	Frequency drive will go to sleep at. Be sure to set this at or higher than the mimumum frequency (F.26)
11	H	63	Wake up level Deviation	35%	0-100	Typically set to 10%	Level drive wakes back up. This is the deviation level from the set-point that the drive wakes back up at.
12	Drv	ref	PID Set point	0	0-400Hz	Depends on the system requirement	Level you want drive to maintain units will be in Hz or % Depends on H58
13
14	Additional Functions and Notes
15	If Thrust speed is needed for Submersible pump Application you must do as follows:
16	H	22	Speed Search	All Low	Low or High	Set bit 0 to high(bit all the way on the right)	Make sure you set the bit farthest to the right high
17	F	24	Frequency Lower Limit(Enable)	0-1	0-1	1 (Enable)	Allows lower limit setting in F.26
18	F	26	Frequency Lower Limit value	0.5Hz	0-max speed	30 Hz	Actual Thrust speed needed(e.g.30Hz)
19	H	56	PID Lower Limit	0.5Hz	0-max speed	30 Hz	Set this to the same as F.26.
20							Rev E
21
22
23
24
25
26
27
28
29
30
31
32
33
34
35
36
37
38
39
40
41
42
43
44
45
46
47
48
49
50
51
52
53
54
55
56
57
58
59
60
61
62
63
64
65
66
67
68
69
70
71
72
73
74
75
76
77
78
79
80
81
82
83
84
85
86
87
88
89
90
91
92
93
94
95
96
97
98
99
100