Assembly
Wheel Assembly
Remove Horn from Servo
Keep the screw! We don't have extras!
Put the screw back into the servo when the horn is off.
Tape Screws (8) to Wheel (16)
Add Spacers (14) Half Drive Wheel (15) and Outer Wheel Disk (18)
BE SURE that the two small holes in the center line up!
Add Lock Nuts (9)
You can remove the tape when the nuts are on.
Add Servo Horn as Shown
Add Inner Wheel Hub (13)
Slip O-Ring (17) into the Wheel Groove
Base Assembly
Add the Rear Panel (4) to the Side Panel (1)
LOOK AT THE HOLES.
The holes at the bottom are shifted to the left.
Add the Bottom Panel (3)
Look at the hole position...
Add the Front Panel (2)
Attach the Remaining Side Panel (1) with Nuts (28) and Bolts (5)
Add Servos Motors
Note: The horn goes toward the front.
Add Small Wheels (12) with Nuts (9) and Screws (8)
Add Arduino
Use M3 Screws (6), Spacers (23), and M3 Nuts (7)
Add Wheel Assembly
Add Velcro Strip (19)
Secure Velcro Strip with Sticky-Back Velcro (21) - Use FUZZY side
The End