1 of 10

M.S.E., BARIPADA-757107

Department of Civil Engineering

Semester- 5^th

Subject- Railway & Bridge Engineering

Presentation on

“ Wear of Rail “

By :- ER. SAROJ KUMAR NAYAK

2 of 10

INTRODUCTION TO WEAR OF RAIL

The separation or cutting of rail due to friction and abnormal heavy load is called wear. There are three types of wears of rail :-

Wear of Rails on top OR Head of Rail
Wear at the End of Rails
Wear at the side of head of Rails or wear on rail on curves

4 of 10

WEAR ON HEAD OF THE RAIL

The metal from the top of rail flows and forms projections which are known as burns. The causes of such types of wear are:

Rails are worn out on top due to abrasion of the rolling wheels over them.
The heavy wheel loads are concentrated on very small areas.
Impact of heavy loads
Corrosion of metal of rails
Due to slipping action of wheels during starting and when brakes are applied to the moving trains, the metal of top of rail burns.

5 of 10

WEAR AT END OF RAILS

This wear of rails takes place at the ends of rails and is found to be very much greater than the wear at the top of rails. At the expansion gap, the wheels of the vehicle have to take a jump and during this jump, they impart a blow is the ends of the rails. This blow is the main cause of wear of rails at ends. Due to successive blows, the ends of the rails are battered

6 of 10

CONTINUED…

The ballast under the sleepers will loosen due to increase in the intensity of vibrations, also he sleeper will depressed due the displacement of ballast, also the fish plates will get loose under the constant impact of increasing vibrations

7 of 10

Wear at the side of head of Rails

This is the most destructive type of wear and occurs on the rails laid on curves. The various causes of side wear of rails are:

Due to centrifugal force along the curvature, the grinding action of wheel flanges on the inner side of the head of the rails is caused.
The vehicles do not bend to the shape of the curvature while moving over a curve. This results into the biting of the inner side of the head of outer rail by wheel flanges..

8 of 10

Wear at the side of head of Rails Contd…

The wear on the inner side of the head of inner rail is mainly due to the slipping action of wheel on curve. Outer wheels have to cover a longer distance than inner wheel as “pq” is greater than “rs”. But due to rigid connection between two wheels, they cover the same distance and hence then inner wheel slips over the inner rail, resulting in the wear of inner side of head of inner rail.