K-ADP-USB
Using PACTware DC 6.1 and the DTM driver file
Install the K-ADP-USB driver DTM Collection Interface Technology 2 / DTM Collection Interface Technology 2
Download and install PACTware 6.X / PACTware 6.X
RUN PACTWARE DC make new DC
Restart the pactware DC software a few times helps find the driver.
Select communication port USB 1 K-ADP-USB
Run this one PACTware DC 6.1
Set to: USB 1 K-ADP-USB
For The KFD2-UT2-EX1 select
KF*-UT2-*FDT
Read to check comms
Adjustments can be made here,
Then write to device once complete
Front panel Fault LED
https://files.pepperl-fuchs.com/webcat/navi/productInfo/doct/tdoct0735e_eng.pdf?v=20230403152657
Page 11 :
5.3 Controls and indicators of the UT2 On the front panel of the UT2 you will find:
• LED ERR 1 (red) to indicate
a lead fault at input 1 (terminals 1 to 3; flashes red)
the simulation mode (flashes red)
a device fault (steady red)
Page 16 of this manual might help find the why the fault led is on too, under the device status.
K type Red Pin 1
K type Blue Pin 2
1,2,3
4,5,6
7,8,9
13,14,15
n/c
PIN 14 +24v dc
PIN 15 - 0v dc
Power supply
7 PIN 7 + 4- 20ma
9 Pin 9 -ve 4 - 20ma
Power supply
+ve 24vdc -ve
Plc Analog input*
Configuration:
For a K type
External Loop powered current output:
Using pins 9(-) and 7(+)
Pin 8(+) pin 7(-) is used if a active 4-20ma is required
+I
+v
-0v
PIN 7 4- 20ma
Pin 9 -ve 4 - 20ma
Power supply
-ve 24vdc +ve
-VE IN
TEST METER
+VE IN
ALTERNATIVE TEST SETUP
K type Red Pin 1
K type Blue Pin 2
1,2,3
4,5,6
7,8,9
13,14,15
n/c
PIN 14 +24v dc
PIN 15 - 0v dc
Power supply
7 PIN 7 - 4- 20ma
8 Pin 8 +ve 4 - 20ma
Configuration:
For a K type
Internal Loop powered current Output:
Using pins 8(+) and 7(-)
Pin 8(+) pin 7(-) is used if a active 4-20ma is required
Often used with a loop powered isolator, or direct connect display panel meter.