Dr. Ahmad Abdel Aziz
Biometric guides to complete denture construction
Secondary impressions
These are carried out using either:
Space in the mouth formerly occupied by teeth and the supporting tissues which have since then been lost.
- The space in which the denture is allowed to be (Beyond which not allowed to extend!!)
- The space which should be filled by the denture.
- The ideal space for placing the denture (that will enhance the denture both functionally and esthetically!!)
The representation of the lost tissues in approximately the same amounts and positions as the lost tissues.
Have a successful replacement of the lost tissues.
These are present with all cases with no previous dental records (pre-extraction records). Here we are forced to make our own judgment as to the shade, shape and amounts of teeth and supporting structures and their positions.
Construction of a maxillary biometric tray
Palatal gingival vestige: A raised fibrous ridge on the palatal surface of the upper residual ridge distinguishes the palatal mucosa from the vestibular mucosa and can be used as a guide to positioning maxillary teeth
the incisive papilla and the palatal-gingival margin (the remnant of the gingival margin on the palatal side of the dental arch, which after tooth extractions often remains visible as a cordlike elevation) work as landmarks for estimating the preextraction dimensions of the ridge.
The distance between the palatal gingivae and the labial or buccal surface of the teeth is termed the buccopalatal breadth. This on average about 6 mm in the incisor region, 8mm for the canines, 10 mm for the premolars and 12mm for the molars. Therefore, by distinguishing the palatal gingival vestige, the position of the labial surface of the artificial teeth can be readily identified
Construction of a maxillary biometric tray��1) Take the preliminary impression so that the preliminary cast represents the full suclus width.��2) On the cast from the preliminary impression, make a pencil line 5 mm on the sulcus side of the mucogingival line to indicate the depth of the buccal flange of the upper tray
3) Fill the buccal sulcus with wax to form a horizontal ledge of wax round the upper cast at the level of the pencil line.
4) With a pair of calipers mark on the wax the approximate average buccolingual horizontal measurements from the remnant of the lingual gingival margins. Sagittally in the incisor region and coronaily in the other regions, these
measurements are
approximately
6 mm (incisor), 8 mm (canine),
10 mm (premolar)
and 12 mm (molar).
5. Draw a line on the wax joining these measurements together.
6. On the cast lay down a wax spacer of appropriate thickness to provide room for the impression material to be used.
7. Make a tray so that the outer surface of the periphery lies on the line marked on the wax ledge.
MANDIBULAR BIOMETRIC TRAY
Measurements of the kind made on the maxillary cast are not practicable on mandibular casts
Biometric lower trays are constructed to prevent the inward collapse of lips and cheeks and to hold them in their former upright positions, so that the impression material is supported as it runs round the edge of the tray and up between the tray and tissues.
The front of the biometric tray slopes forward to support the lower lip and in this way the labial sulcus is correctly defined. In the molar region the buccal flange of the tray is thickened so that the impression material is supported to delineate the form of the buccinator as its middle fibers sweep lingually towards the pterygomandibular raphae