The Quality Control Requirement of Thera75 v2

A1

A3

A2

Top case

1. Grade A surface is not allowed to appear scratches, bright lines, knife lines, oxidized white points/different colors and other defects; Allow the diameter of defect points ≤0.2mm, spacing ≥100MM, but not more than 2 points;

2. Grade B surface is allowed to appear slight scratches, bright/dark lines, knife lines, burrs, white spots, etc. The screw hole and hanging point are controlled according to B level surface, and the size of the screw hole is less than 2mm; Hanging point D≤2.0mm line length ≤4.0mm;

Tips:The above marked areas A1 and A2 are controlled according to Grade A standards, and marked areas A3 are controlled according to grade B surface.

A1

1. Grade A surface is not allowed to appear scratches, bright lines, knife lines, oxidized white points/different colors and other defects; Allow the diameter of defect points ≤0.2mm, spacing ≥100MM, but not more than 2 points;

2. Grade B surface is allowed to appear slight scratches, bright/dark lines, knife lines, burrs, white spots, etc. The screw hole and hanging point are controlled according to B level surface, and the size of the screw hole is less than 2mm; Hanging point D≤2.0mm line length ≤4.0mm;

Tips:The marked A1 area above is controlled according to grade A standard, and the footpad holes and counterweight slots in the marked A2 area are controlled according to grade B surface; Marked A3 area is controlled by grade B.

A2

A3

Bottom case

A2

A1

Stainless steel PVD:

1. Grade A surface is not allowed to appear scratches, plating white spots/different colors and other defects; It is allowed that the diameter of defect points is less than 0.2mm, the spacing is more than 80MM, but not more than 2 points;

2.Grade B surface is not strictly controlled, no obvious protruding point, deformation, lack of material, impurity point can be accepted;

Tips:The marked A1 area above is controlled according to the grade A standard, and the marked A2 area is controlled according to the grade B surface standard.

Stainless steel PVD Weight

A2

A1

1. Grade A surface is not allowed to appear scratches, bright lines, knife lines, oxidized white points/different colors and other defects; Allow the diameter of defect points ≤0.2mm, spacing ≥15MM, but not more than 2 points;

2. Grade B surface is allowed to appear slight scratches, bright/dark lines, knife lines, burrs, white spots, etc. The screw hole and hanging point are controlled according to B level surface, and the size of the screw hole is less than 2mm; Hanging point D≤2.0mm line length ≤4.0mm;

The marked A1 area above is controlled according to the grade A standard, and the marked A2 area surface is controlled according to the grade B standard.

Badge Accessories