Lab Safety Assessment
85% or higher is passing. Successful completion will grant the student with a RFID fob or card for door access. This will allow students full access to the lab during normal hours(8-5) as well as access to the lab after hours with the caveat that some equipment will be locked out past 5pm.
Email *
Name *
0 points
Course Number *
Eye protection must be worn: *
1 point
Long hair is to be secured by ________ when operating machinery *
1 point
Which of the following is safe to wear when operating machines in the shop: *
1 point
Wrenches or other tools can be used on moving machinery: *
1 point
Horseplay is allowed: *
1 point
Machinery and equipment can only be operated when: *
1 point
In the event of an injury or accident, you should immediately report it to:(check all that apply) *
1 point
Required
Why would ABS be a poor choice to cut with a laser cutter? *
1 point
1/2" polycarbonate is easily cut by the laser cutter. *
1 point
Faulty equipment, or tooling should be: *
1 point
Always stop a machine before___________. *
1 point
Broken tools or cutters should: *
1 point
When you have completed an operation on a machine, turn off the power and wait until the cutting tool has come to a stop before leaving the area or setting up another operation. *
1 point
Never leave a machine running or unattended under any circumstances. *
1 point
If you or someone else is injured while in the lab you should leave before anyone notices. *
1 point
Stopping a work-holding device by hand is an acceptable practice while working on rotating machinery. *
1 point
True or False: The table saw is good at making curved cuts. *
1 point
What is the technical term for the shark fin of a table saw located aft of the blade *
1 point
When using the horizontal band saw it is acceptable to hold the stock to be cut with your hands. *
1 point
Which type of saw is best for long straight cuts in wood? *
1 point
Long deep holes are best drilled using a technique called peck drilling. *
1 point
When using the laser cutters the central vent system should be activated... *
1 point
True or False: The table saw table is a good place to work on projects *
1 point
The teeth of a table saw blade should be about(___)" about the piece to cut. *
1 point
What type of materials can be ground on a bench/pedestal grinder? *
1 point
Using the suggested drill speed chart: Would a 1/2" drill need to spin faster or slower than a 1/4" drill to maintain the proper SFM? *
1 point
When drilling what is the best way to hold the work piece. *
1 point
When making cross cuts on a table saw which guide would be used? *
1 point
A copy of your responses will be emailed to the address you provided.
Submit
Never submit passwords through Google Forms.
reCAPTCHA
This content is neither created nor endorsed by Google. Report Abuse - Terms of Service - Privacy Policy