Motorized Miter Saw Safety and Operation Test
How must the saw blade be held after the cut is finished and before the blade stops rotating?
release it to the up position
hold it in the down position
raise 1" above the stock being cut
pull to the out position
What special protection must be observed when using the motorized miter saw outside?
keep the saw covered
lubricate the saw more often than normal
unplug the saw after each cut
connect the saw to a ground fault circuit interrupter (GFCI)
How can the saw operator prevent the blade from binding when cutting warped, bowed, or long stock?
clamp the stock to the table
hold the saw firmly
push the saw through the material slowly
hold the saw down securely after the cut is made
When is it safe to remove wood scraps form the cutting zone on the motorized miter saw?
while the saw is positioned over material and ready for a cut to be made
while the saw blade is clamped in the down position
while the saw is off and the hand is not on the off/on switch
while the blade is up
Where should the saw blade be positioned when cutting is completed and the operator is leaving the work zone?
in its safest position
either a or b
Hands or fingers never come closer than ___ to the rotating blade when operating the motorized miter saw.
What personal protection equipment should be worn by a motorized miter saw operator?
hearing protection, eye protection, and a dust mask
eye protection and hearing protection
hearing and eye protection, dust mask, and gloves
The purpose of a trial cut before making the actual cut with the motorized miter saw is to ___.
see if the material is positioned correctly
see if the saw is cutting properly and is set accurately
see how the material will cut
test the sharpness of the saw blade
Where should the saw blade be aligned when making a cut with the motorized miter saw?
left side of the marking line
right side of the marking line
waste side of the marking line
on the marking line
How should the saw blade be moved throughout the stock when making a cut with a motorized miter saw that has a sliding arm?
push down, then pull out
pull out then push down
pull out, push down, then push forward
The purpose of a "stop" when making multiple cuts with the motorized miter saw is to ___.
hold the stock securely
improve cut accuracy and reduce time required to make cuts
reduce time required to make cuts
get hands and fingers further away from the cutting zone
If a kickback should occur when a cut is being made the saw operator should ___.
jump out of the way
turn loose of the saw immediately
raise the saw to the up position immediately
hold the saw firmly in the down position and release the on/off switch
Never submit passwords through Google Forms.
This content is neither created nor endorsed by Google.
Terms of Service