True or False: I should hold my piece in one spot of the wheel to only flatten a piece.

What happens to the wheel when the disc is left on while the machine is still and drying?

How do you clean up the silica to remove it from the trough of the machine after every use?

How tight should the bolt be on the saw blade before the machine is turned on? (Auto Fail)

True or False: I can use oil based clay to jig my piece and secure it before cutting?

What area of the saw needs to be rinsed down after use and what area should not get wet?

How do you take off the blade and store it after every use? What area of the saw needs to have the chunks of glass removed from it and be thoroughly rinsed of all remaining Silica?

When is the only time the drift key can be off the top of the lathe(where it lives for safety)? (Auto Fail)

What is the only way to attach the spindle to the arbor? How do you take the spindle off the arbor when you’re done? 

How much water should be added to the wheels or disc?

Is it better to add the cerium slurry to the area of the piece you’re workin or to the wheel/disc?

How long do the wheels need to be left spinning on the machines minimum after any use to allow them to dry without warping?

When is the only time the covers can be off of the cerium wheels? Can they be on while the wheels are spinning from the timed dry time? 

What are two acceptable materials to be use for masking the area to protect glass from sandblasting? What are two materials that you cannot put on your piece in the sandblaster? What happens if you use the wrong materials that contaminate the Sandblast grit?

True or False: I can hold the piece while blasting it. 

How long should the machine be left running before flipping off the switch and opening the door to get your piece out?

True or False: You need to wear a respirator while using the Sandblaster.

What things you should do before turning on the sandblaster each day?

Where are these 4 compressor water traps located that need to be emptied before the Sandblaster is used? What happens if the compressor traps are not emptied?

What do you put into the handpiece before attaching it to the machine and how much?

What tool do you use to change the bits in and out of the hand piece? How do you use it?

How many items need to be cleaned and put away when you’re taking apart the Flex shaft?

Which water valves must be turned off when exiting the shop for the day? 

Where should you direct the water as you are hosing down the floor at the end of a session?

True or False: I should rinse every towel I have used in the sink and leave them to dry.