JavaScript isn't enabled in your browser, so this file can't be opened. Enable and reload.
DIESEL FIRE PUMP
PRE-STARTUP CHECKLIST
Sign in to Google
to save your progress.
Learn more
Company
Your answer
Project:
Your answer
Name:
Your answer
Contact Info:
Your answer
Storage and Installation procedure as outlined in the submittal and IOM Manual have been followed.
Yes
No
Clear selection
Contractor has informed Fluid Solutions LLC of any noted damage occurred during shipment, storage, or installation including inspection inside controllers for mechanical damage.
Yes
No
Clear selection
Contractor has anchored and grouted skid/pump base as required by the IOM.
Yes
No
Clear selection
Contractor has completed all piping connections to pump skid this includes: test header, suction, and discharge.
Yes
No
Clear selection
Contractor has completed piping all necessary drain lines and has installed heat exchanger discharge to drain with separate piping viewable in the pump room.
Yes
No
Clear selection
Contractor has completed the fuel system fill and return piping, and ventilation as required by NFPA 20.
Yes
No
Clear selection
Contractor has connected the NFPA 20 required fuel tank alarm interconnections between the fuel tank and the fire pump controller: low level alarm & leak detection.
Yes
No
Clear selection
Contractor has correctly installed vortex plates and suction piping (if water is supplied by tank)
Yes
No
Clear selection
Confirm that pump room has the required ventilation louvers and exhaust fan.
Yes
No
Clear selection
Contractor has connected power to the fire pump & jockey pump controllers and engine jacket heater, and confirmed correct power is available.
Yes
No
Clear selection
Contractor has filled fire water tank to appropriate level with clean water. (if it is fed from a water tank). Confirm that all suction valves are open.
Yes
No
Clear selection
Contractor has filled & labeled the fuel tank with No. 2 Diesel.
Yes
No
Clear selection
Contractor has completed all Fire Alarm interconnections to the Controller. Fire pump will not be left in service if it is not constantly monitored by the fire alarm panel.
Yes
No
Clear selection
Contractor has installed muffler & exhaust piping.
Yes
No
Clear selection
Contractor will ensure that batteries are filled, connected, and charged before technician arrival
Yes
No
Clear selection
Contractor will not allow anyone to operate the system until approved by Pump Representative.
Yes
No
Clear selection
Contractor will have electrician and installer representative available the morning of scheduled start up.
Yes
No
Clear selection
The Sprinkler System is complete and ready to be put into service
Yes
No
Clear selection
Submit
Clear form
Never submit passwords through Google Forms.
This content is neither created nor endorsed by Google.
Report Abuse
-
Terms of Service
-
Privacy Policy
Forms
