ECD Testing - Notification

Die Datei kann in Ihrem Browser nicht geöffnet werden, weil JavaScript nicht aktiviert ist. Aktivieren Sie JavaScript und laden Sie die Seite noch einmal.

Regulation No. 7, Part D, Section II.B.2.h requires performance testing for enclosed combustion devices (ECD) statewide. Section II.B.2.h.(iii) requires notification (no later than July 31, 2022) to the Air Pollution Control Division by owners or operators of ECD(s) that are subject to Section II.B.2.h.(ii) and that commenced operation before December 31, 2021.

Use this form to fulfill the notification requirements of Section II.B.2.h.(iii). No later than July 31, 2022, complete and submit a form for each individual ECD.

If you own or operate multiple ECDs, after submitting the form select the option to "Submit another response" to report another ECD. Only ECDs that commenced operation before December 31, 2021 need to be included in this notification.

In Google anmelden, um den Fortschritt zu speichern. Weitere Informationen

E-Mail-Adresse *

Company Name *

Contact (First and Last Name) *

Facility Name *

Location in decimal Latitude *

Location in decimal Longitude *

AIRS ID (either xxx-xxxx, or xxx-xxxx-xxx). If unknown or not yet assigned, enter "TBD". *

ECD manufacturer *

ECD model *

ECD serial number or unique identifier *

List all equipment controlled by the ECD, including AIRS ID where available (xxx-xxxx-xxx). *

What time period will the ECD be tested to meet the compliance schedule in Table 1 of Reg. 7 Part D Section II.B.2.h.(ii)? *

Is the facility/ECD: inside the 8-hour ozone control area and northern Weld County; outside the 8-hour ozone control area and northern Weld County, and/or within a disproportionately impacted (DI) community? (See Reg. 7, Part D, Section II.A.11. for the definition of "DI Community") *

Within a DI community

With in the 8-hour ozone control area and northern Weld County

Outside the 8-hour ozone control area and northern Weld County

Not sure

Pflichtfrage

Has the ECD completed an initial performance test to satisfy Reg. 7 Part D Section II.B.2.h.(ii)(B)? *

Yes

If the ECD has completed the initial performance test, what date was the test completed?

Datum

What were the results of the initial performance test? (i.e., Pass or Fail, and %DRE measured)

Do you consider the ECD to be "intermittent flow" or "low-flow"? "Intermittent flow" is when waste gas from the controlled equipment is sent to the ECD non-continuously, such as from periodic dump events from a storage tank. "Low-flow" is when the waste gas has a small continuous volumetric flow rate from the controlled equipment that may make reaching full test-run time possible. *

Intermittent flow

Low-flow

I do not know

Neither option

The Division is developing a standard protocol for traditional combustor testing methods. Once available, do you plan on using this standard protocol for this ECD? If not, you will be required to develop a site-specific testing protocol subject to review by the Division prior to testing. Please note that the standard protocol may not be appropriate for "intermittent flow" and/or "low flow" scenarios.

Yes

Unsure at this time

Auswahl löschen

(Optional) Use this space to provide any additional comments about this ECD.

Kopie meiner Antworten an mich senden

Senden

Alle Eingaben löschen

Gib niemals Passwörter über Google Formulare weiter.

reCAPTCHA

Datenschutz Nutzungsbedingungen

Dieses Formular wurde bei State.co.us Executive Branch erstellt.

Sieht dieses Formular verdächtig aus? Bericht

Formulare