RNPCP Quiz #8 - Master Plumber Licensure Examination

JavaScript isn't enabled in your browser, so this file can't be opened. Enable and reload.

RNPCP Quiz #8 - Master Plumber Licensure Examination

Hello Future RMPs. This will serve as your Quiz #8 for RNPCP

Email *

Record my email address with my response

1. What must be done if a plumbing or drainage system is covered before it has been inspected and approved? *

1 point

A. The system may remain covered if testing was done

B. The system shall be uncovered for inspection and testing upon notice

C. The permit shall be automatically revoked

D. Only partial inspection is required

2. Who is responsible for furnishing the equipment, materials, and labor required for plumbing inspections or tests? *

1 point

A. The Administrative Authority

B. The Plumbing Inspector

C. The person to whom the permit is issued or who requests the inspection

D. The material supplier

3. What testing media may be used to test the plumbing, drainage, and venting system? *

1 point

A. Smoke or dye

B. Water or air

C. Steam only

D. Chemical solution

4. When performing a water test on an entire system, which opening is allowed to remain open? *

1 point

A. The lowest opening

B. Any vent opening

C. The highest opening

D. All clean-outs

5. What is the minimum pressure and duration required for an air test? *

1 point

A. 20 kPa for 10 minutes

B. 34.5 kPa for at least 15 minutes

C. 50 kPa for 5 minutes

D. 254 mm mercury for 5 minutes

6. How shall a building sewer be tested to verify water-tightness? *

1 point

A. By applying air pressure only

B. By plugging the sewer at the point of discharge only

C. By plugging the sewer at its connection and completely filling it with water or using an approved equivalent low-pressure air test

D. By visual inspection only

7. What is the minimum pressure requirement when testing water piping systems using water? *

1 point

A. Equal to the working pressure

B. 25% higher than the working pressure

C. 50% higher than the working pressure

D. 100% higher than the working pressure

8. What alternative pressure may be used when testing water piping systems instead of water? *

1 point

A. 34.5 kPa air pressure

B. 68.9 kPa air pressure

C. 254 mm mercury pressure

D. 101.3 kPa air pressure

9. When shall an air test be used for defective plumbing systems? *

1 point

A. During initial installation only

B. When visual inspection is inconclusive

C. When there is reason to believe the system has become defective

D. Only after system failure

10. How are shower receptors tested for water-tightness? *

1 point

A. By applying air pressure to the drain

B. By visual inspection only

C. By filling with water to the level of the rough threshold

D. By running water for five minute

11. Who is responsible for maintaining the plumbing and drainage system of a premises in a sanitary and safe operating condition? *

1 point

A. The Plumbing Inspector

B. The Administrative Authority

C. The owner or his agent

D. The Registered Master Plumber

12. Under what condition may changes be required to plumbing systems in existing buildings? *

1 point

A. When new codes are issued regardless of condition

B. When the building is renovated

C. When the system is found to be dangerous, unsafe, insanitary, or a nuisance

D. When ownership of the building changes

13. Which of the following best describes the intent of the provisions on existing construction? *

1 point

A. To require all old systems to be upgraded

B. To exempt all existing buildings from regulation

C. To protect compliant existing systems unless they pose hazards

D. To allow unsafe systems to continue operating

14. What action is required if compliance with the Code fails to eliminate a health or safety hazard *

1 point

A. No action is required

B. The owner must close the building

C. The owner or his agent must install additional facilities or make repairs

D. The system must be demolished

15. Who has the authority to order repairs or alterations to eliminate plumbing-related health or safety hazards? *

1 point

A. The building owner

B. The Registered Master Plumber

C. The Plumbing Authority

D. The Local Health Officer only

16. What condition must be maintained for plumbing and drainage systems under the Code? *

1 point

A. Economical and efficient condition

B. Aesthetic and concealed condition

C. Sanitary and safe operating condition

D. Temporary and serviceable condition

17. Which party has jurisdiction over the maintenance of plumbing systems within a premises? *

1 point

A. The local health officer

B. The plumbing authority

C. The building contractor

D. The design engineer

18. Which statement correctly applies to plumbing systems installed before the effectivity of the Code? *

1 point

A. They must always be replaced

B. They are exempt from all inspections

C. They may remain if compliant with prior laws and not hazardous

D. They must comply immediately with all new provisions

19. Who determines whether an existing plumbing system poses a danger or nuisance? *

1 point

A. The building owner

B. The plumbing contractor

C. The Administrative Authority

D. The local barangay official

20. Which situation requires corrective action even if the plumbing system complies with the Code? *

1 point

A. When fixtures are outdated

B. When water pressure is low

C. When a health or safety hazard still exists

D. When newer materials become available

A copy of your responses will be emailed to .

Submit

Clear form

This content is neither created nor endorsed by Google. - Terms of Service - Privacy Policy

Does this form look suspicious? Report

Forms