Rules of industrial safety during operation of load-lift mechanisms

JavaScript isn't enabled in your browser, so this file can't be opened. Enable and reload.

Full name *

Name of company *

1. In which of the following cases was the safety requirement violated during loading and unloading operations with a crane? *

1 point

a load is lifted, the weight of which is equal to the maximum lifting capacity of the crane;

a load was lifted for which a slinging scheme has not been developed in the presence and under the guidance of a person responsible for the safe performance of work on the movement of goods by cranes;

the load was lifted to a height of 200 mm, with a stop to check the correctness of the slinging and the reliability of the brakes;

the cargo was dragged along the ground using guide blocks that ensure the vertical position of the cargo ropes; for lifting the load, a general-purpose sling with an angle between the branches of 120 degrees was used.

2. Which of the listed persons issues permission to start the work of the lifting machine? *

1 point

chief mechanical engineer;

Chief Engineer;

section head;

Engineering and technical worker for supervision of the safe operation of cranes;

representative of the subdivision of the territorial authorized body.

3. Which of the listed types of hoisting machines are not covered by the Industrial Safety Rules for the design and safe operation of hoisting mechanisms ? *

1 point

winches for lifting cargo and (or) people;

for pipelayers;

excavator cranes designed to work with a hook suspended on a rope;

on winches designed for lifting loads;

on electric hoists .

4. What law applies to the rules for ensuring Industrial safety under the GPM. *

1 point

a ) Articles 14-2 of the Law of the Republic of Kazakhstan dated April 15, 2014 "On civil protection"

b ) Articles 12-2 of the Law of the Republic of Kazakhstan dated April 11, 2014 "On civil protection"

c ) Article 13-2 of the Law of the Republic of Kazakhstan dated April 11, 2015 "On civil protection"

d ) Article 17-3 of the Law of the Republic of Kazakhstan dated April 12, 2015 "On civil protection"

5. What documents are used to register self-propelled load-lifting machines in the territorial subdivision of the authorized body? *

1 point

according to the written application of the owner and the passport of the load-lifting machine.

according to the passport of the lifting machine;

at the written request of the manufacturer;

according to the act of checking installation work and drawings;

statement of the owner and the passport of the lifting mechanism.

6. Which of the following persons can be appointed as a signalman? *

1 point

any person who has learned the rules for signaling;

any person trained in the slinger program;

persons from among the slingers who have extensive experience in practical work as a person responsible for the safe performance of work with cranes;

a person instructed on the procedure for giving signals;

any technological worker of a shop or section.

7. Under which of the following conditions is it allowed to lift and move cargo with several jib cranes? *

1 point

under the direct supervision of the person responsible for the safe performance of work on the movement of goods by cranes, subject to ensuring an equal load on each crane, regardless of its carrying capacity;

when working on a project developed by an organization performing this work under the direct supervision of a person responsible for the safe performance of work on moving goods by cranes;

when working on a project developed by a higher organization, while ensuring an equal load on each crane, regardless of its lifting capacity;

under the direct supervision of the person responsible for the safe performance of work on the movement of goods by cranes;

when performing work in accordance with the flow chart developed by a specialized organization, while ensuring the load on each crane does not exceed its carrying capacity, under the direct supervision of the person responsible for the safe performance of work on moving goods by cranes;

lifting and moving the cargo is carried out in accordance with the work organization project or technological regulations, which contain schemes for slinging and moving the cargo, indicating the sequence of operations, the position of the cargo ropes, the requirements for the state of the track and other instructions for the safe movement of the cargo. The work of moving cargo with several cranes is carried out under the direct supervision of the person responsible for the safe performance of work by cranes.

8. In which of the following cases is the list of transported goods with an indication of their weight necessarily given to crane operators and slingers? *

1 point

crane operators and slingers servicing self-propelled jib cranes during construction and installation works ;

when working with bridge type cranes;

in the event that slinging schemes have not been developed for the transported goods;

when working with cranes of any type;

the need to issue a list of goods to be moved is determined by the person responsible for the safe performance of work on the movement of goods by cranes.

9. Under which of the following conditions is it allowed to work with a crane in case of insufficient lighting of the place of work, if the crane operator does not distinguish between the signals of the slinger or the load being moved? *

1 point

permitted according to a special instruction approved by the head of the enterprise;

permitted when an additional signalman is allocated;

permitted under the direct supervision of the person responsible for the safe performance of work on the movement of goods by cranes;

allowed after additional instruction of the slinger;

not allowed (stop).

10. At what overload value should the load limiter on the jib crane operate? *

1 point

when the weight of the lifted load is exceeded by at least 15% of the nominal lifting capacity of the crane;

when lifting a load, the mass of which exceeds the rated load capacity by more than 10%;

when the weight of the lifted load is exceeded by at least 20% of the nominal lifting capacity of the crane;

when the weight of the lifted load is exceeded by at least 25% of the nominal lifting capacity of the crane;

when the weight of the lifted load is exceeded by at least 5% of the nominal lifting capacity of the crane.

11. Under what conditions is it allowed to work with a jib crane under the non-disconnected contact wires of urban transport? *

1 point

not permitted under any circumstances;

allowed under the supervision of a representative of the enterprise operating this network;

allowed when ensuring the distance between the crane boom and the contact wires is at least 1,000 mm. when installing a limiter (stop), which does not allow to reduce the specified distance when lifting the boom;

it is allowed if the crane is grounded and the work is carried out under the supervision of a person responsible for the safe performance of work on the movement of goods by cranes;

it is allowed when ensuring the distance between the crane boom and the contact wires is at least 0.5 m. when installing a limiter (stop) that does not allow reducing the specified distance when lifting the boom, and in the presence of a person responsible for the safe performance of work on moving goods by cranes.

12. Which of the listed persons issues a permit for the commissioning of a newly installed crane, subject to registration in the territorial subdivision of the authorized body? *

1 point

engineering and technical worker for the supervision of lifting machines at the enterprise;

the person responsible for the maintenance of lifting machines at the enterprise in good condition;

chief engineer of the enterprise;

engineer and technical worker to supervise the safe operation of cranes. Conducting a technical examination can be carried out by a specialized expert organization on the basis of an agreement.;

a person responsible for the safe performance of work on the movement of goods by cranes.

13. Under what conditions should cargo be tilted by cranes? *

1 point

under the guidance of a person responsible for the safe movement of goods by cranes;

under the direction of the chief engineer;

not permitted under any conditions;

with the permission of the regulatory authorities;

can be carried out on tilting sites or in specially designated places, only according to the technological regulations.

14. What is the frequency of checking the inspection of removable load-handling devices and containers by a slinger? *

1 point

daily;

monthly;

once a quarter;

10 days;

before using them .

15. Under what conditions can people be lifted by cranes? *

1 point

tower cranes;

overhead cranes;

not possible in all cases;

with the permission of the person responsible for the safe performance of work;

in exceptional cases, in a specially made cabin after the development of measures to ensure the safety of people.

16. Where and by whom are the results of the technical examination of the hoisting machine reflected? *

1 point

in the passport, by the person who conducted the examination, indicating the date for the next examination;

in the "Journal of the Crane Operator", the mechanic of the enterprise;

a special act signed by members of the commission;

in the passport, the district inspector territorial subdivision of the authorized body;

in verification documents, by the inspector of the territorial subdivision of the authorized body.

17. The marking tag of the sling indicates *

1 point

a) manufacturer's trademark, sling number, sling capacity, test date

b ) manufacturer, sling length, sling capacity, test date

c ) manufacturer, sling number, sling capacity, date of inspection, next. test date

d ) manufacturer, sling number, sling capacity, test date, survey date

18. Using the crane to work during its repair: *

1 point

a) not allowed

b) allowed

c) is allowed, after obtaining written permission from the head

19. In what case is it allowed to lift and move vessels under pressure (cylinders with compressed gases) with a crane, the lifting mechanism of which is equipped with a friction or cam clutch? *

1 point

permitted in any case under the direction of the person responsible for the safe performance of work on the movement of goods by cranes;

permitted in all cases without exception;

not allowed ;

it is allowed if a technological map for the specified work is developed;

allowed in special containers .

20. What is the angle between the branches when calculating a general purpose rope sling with two branches? *

1 point

did not exceed 90;

did not exceed 60;

the angle that is practically formed when lifting a load of maximum weight;

did not exceed 45;

did not exceed 120.

Submit

Clear form

Never submit passwords through Google Forms.

This content is neither created nor endorsed by Google. Report Abuse - Terms of Service - Privacy Policy

Forms