Orientation to Circular Saws Quiz

JavaScript isn't enabled in your browser, so this file can't be opened. Enable and reload.

The circular saw that was used for demonstration in the safety video was: *

1 point

a 2.4 HP worm-drive saw

a 5 HP worm-drive saw

a 2.4 HP circular saw

a 5 HP circular saw

When inspecting a circular saw prior to operation: *

1 point

the power cord must be free of nicks and cuts

the blade must have no broken teeth and must be sharp

the deck must be able to freely move up and down

all of the above are correct

Proper procedure for operating a circular saw includes which of the following? *

1 point

the blade depth must be set twice as deep as the material is thick

the blade must stop spinning and the lower guard snapped back in place before removing the saw from the material after the material is cut

during the cut, one hand must be on the saw and one hand must hold the material

all of the above are correct

A saw may experience kick-back due to: *

1 point

blade rotating too fast when it enters the material

dry brittle material

blade being too sharp for the material

binding material not allowed to freely fall away

Which of the following would be considered proper safety protocol when using a circular saw? *

1 point

material should be cut between sawhorses for maximum support

knots in material should not be cut through

extra material under the primary material should be kept clear of the path of the blade

material being cut should always be held with one hand

Name *

Date *

YYYY

Submit

Clear form

Never submit passwords through Google Forms.

This form was created inside of Wolf Construction.

Does this form look suspicious? Report