Festool OF1010 Router Quiz Questions

JavaScript isn't enabled in your browser, so this file can't be opened. Enable and reload.

Email *

Name *

Your name as on your Makespace membership

Membership number *

Your Makespace membership number. If you have not been issued with a membership number, please contact admin@makespace.org to get yours. Thank you.

I have read and understood the Risk Assessment for this equipment *

I confirm

Required

Which Personal Protective Equipment is mandatory for the Hand Router? *

Dust Mask

Eye protection

Hearing protection

Required

Which materials is it safe to cut without a dust mask? *

Pine

Aluminium

MDF

Oak

Plywood

Required

When do you need to notify other workshop users? *

When you are producing irritant dust

When they do not have eye protection

When they do not have hearing protection

Required

Which direction do you rout around the outside of a board? *

Clockwise

Anti-clockwise

Which direction do you rout around the inside of a frame? *

Clockwise

Anti-clockwise

Which are acceptable methods for securing a workpiece in Makespace? *

Friction mat

Clamps

Required

What you must ensure is clean before using the router? *

The collet that holds the bit

The bench

The workshop floor

The router

Required

What you must ensure is clean after using the router? *

The collet that holds the bit

The bench

The workshop floor

The router

Required

How far should the bit extend from the router collet? *

0mm

5-10mm

25mm

What final checks do you need to make before making a cut? *

That you will be balanced for the full time you are cutting

That the power cord is behind you away from the cut

That the workpiece is fully secured

That your cutting will not adversely impact the safety of others using the workshop

That you have your Personal Protective Equipment on

Required

If there is an accident: *

Stop the equipment, use the first aid kit above the sink in the mainspace next to the big Makespace logo, use the phone to call 999 if needed, inform management in an email to management@makespace.org

Tell the owners next time you see them

Only be concerned if you are bleeding

Note what happened and try to avoid doing that again in the future

What shank diameter bits fit the Makespace router? *

6mm

8mm

1/2 inch

1/4 inch

Other:

Required

What is the stopper post for?

To guide an edge cut

To limit the depth of the cut

To measure the depth of the cut

To stop you cutting too far along the work piece

Other:

Clear selection

How does the On/Off switch control the power?

Depress to turn on and depress to turn off again

Hold down to keep power on and release to stop

Clear selection

Which adjustments can you make whilst the router is plugged in?

Cut depth

Securing the cutter

Attaching the collar

Adjusting the work piece’s position

None of the above

Clear selection

How do you control the depth of the cut?

Fix with the locking knob

Holding the router down

Positioning the stopper pole so that a chosen depth cannot be exceeded

Clamping the router with a G Clamp

When you start the router how is it positioned?

On the workbench

Held firmly in both hands

With the bit held against the work piece

With the bit held away from the work piece

What can the straight guide be used for?

To stop the router falling off the work piece edge

To round over an edge

To guide cutting a groove at a constant distance from an edge

To enable a constant depth chamfer along an edge

A copy of your responses will be emailed to the address you provided.

Submit

Clear form

Never submit passwords through Google Forms.

reCAPTCHA

Privacy Terms

This form was created inside of makespace.org.

Does this form look suspicious? Report

Forms