HCP SOP Training Questionnaire

JavaScript isn't enabled in your browser, so this file can't be opened. Enable and reload.

Email *

Record my email address with my response

Name of Test Taker *

What should the copper sulphate rod sponge be kept in before the test? *

10 points

Water

Nothing. It can be used directly

Oil

What phase of electricity should be obtained at site? *

10 points

Single Phase

Dual Phase

Triple Phase

Multimeter should be set at what setting? *

10 points

(-)mv

(+)mv

(-)Kv

(+)Kv

Arrange the following steps in the correct order
*

Choose the option with the correct order

10 points

i. Drill a hole in the concrete to reach the reinforcement, ii. Identify test locations with a unique grid number marked on the drawing, iii. A direct Electrical connection to the reinforced steel be established by means of a compression-type ground clamp, or by brazing or welding a protruding rod to the positive terminal of the multimeter, iv. For loose concrete, remove cover to exposed the reinforcement

i. Identify test locations with a unique grid number marked on the drawing, ii. A direct Electrical connection to the reinforced steel be established by means of a compression-type ground clamp, or by brazing or welding a protruding rod to the positive terminal of the multimeter, iii. Drill a hole in the concrete to reach the reinforcement, iv. For loose concrete, remove cover to exposed the reinforcement

i. Identify test locations with a unique grid number marked on the drawing, ii. Drill a hole in the concrete to reach the reinforcement, iii. For loose concrete, remove cover to exposed the reinforcement, iv. A direct Electrical connection to the reinforced steel be established by means of a compression-type ground clamp, or by brazing or welding a protruding rod to the positive terminal of the multimeter

Which step is missing in the following chain of events?
*

1. Attachment must be made directly to the reinforcing steel except in cases where it can be documented that an exposed steel member is directly attached to the reinforcing steel.
2. ?
3. Measure voltage in millivolts.

10 points

2 - Electrically connect one end of the lead wire to the half cell and the other end of the same lead wire to the negative terminal of the multimeter.

2 - Electrically connect one end of the lead wire to the half cell and the other end of the same lead wire to the positive terminal of the multimeter.

2 - Electrically connect one end of the lead wire to the half cell and the one end of a different lead wire to the positive terminal of the multimeter.

When should you pre-wet the concrete surface? *

10 points

If the measured value of the half-cell potential changes or fluctuates with time

If the measured value of the half-cell potential does not change or fluctuate with time

If the measured value of the half-cell potential is a whole number

How long should the reading remain stable after pre-wetting the concrete surface? *

10 points

3 mins

4 mins

5 mins

Where should the test be repeated? *

10 points

Multiple locations of the member only

On different members only

Multiple locations of the member and on different members

A copy of your responses will be emailed to .

Submit

Clear form

Never submit passwords through Google Forms.

This form was created inside of Limaye.org.

Does this form look suspicious? Report

Forms