SPECIFICATION | 2-CELL BATTERY | 4-CELL BATTERY Twice the height of the 2 cell battery |             8-CELL BATTERY Approx 2X  length of 4C battery. (Dims below) |
CHARGING TIME: | 3-4 HOURS | 6-7Â HOURS | Â Â Â 12-14 HOURS |
   DIMENSIONS (Imperial) | 2.2in Wide x 3.3in Length x 1.1in Height | 2.2in Wide x 3.3in Length x 1.8in Height |  2.2 in Width X 5.75 in length X 1.8 in height  |
DIMENSIONS (Metric): | 56mm Wide x 84mm Length x 28mm Height | 56mm Wide x 84mm Length x 46mm Height | 56mm Width x 146mm Length x 46mm Height |
WEIGHT (MetricL): | 0.31 Lbs. (or 140g) | 0.54 Lbs. (240g) |    15.5 Oz  (440g) |
      mAH Rating at 7.2V | 3,400 | 6,800 | 13,600 |
      WH Rating | 24.5 WH | 49 WH | 98 WH |
Lithium Content (g) | 1.6g | 4.1g | 8.2g |
COMPATIBLE WITH: | Any Red taillight, amber headlight or any white headlight with less than 3 LEDs  that uses an external battery | Use this battery with any DiNotte lithium ion system using an external battery  EXCEPT for the XML-8 | Use this battery with any DiNotte lithium ion light that uses an external battery |
PROPER USE: | -Plug in Charger, light flashes Green/red/Green, plug in light  Red = Charging, Green = Fully charged   Green also means no current flow Charge battery before use.  Never leave batteries fully charged or dead between uses Leaving a battery plugged into a light or unplugged charger will drain the battery If a battery does not power a light and the charger does not turn red, it’s likely a problem with the battery cable or the battery is at end of life. Never charge a battery with any other charger, use batteries with DiNotte lighting lights shown above.  |
LONG TERM STORAGE: | When storing a battery, drain battery by plugging it into a light and running it on low, charge battery for 50% of charge time listed above Unplug battery from charger and store. Â Leaving a battery plugged into a light or unplugged charger will drain the battery |
CAUTION: | Never use a DiNotte Battery with any light or charger other than a DiNotte Lighting headlight or taillight NEVER try charging a DiNotte battery with any charger other than a DiNotte Charger. If your battery or charger has been dropped or looks damaged, please do not use battery or charger. Airline maximum battery size is 100WH |
Mounting Instructions
1)Â Unfasten and open strap. Place Battery Pack on bar as shown. Â | 2)Â Feed strap up through slot. (Be sure strap is only going around bar, not brake or shifter cables!) | |||||
3)Â Tighten strap so the battery pack is secure. NOTE: Â Make sure cables move freely. Â Cables may run underneath battery strap. Â | 4)Â Fasten by pulling down and lock it into place. Never install vertically on the tire side or the battery pack will slide down, pulling cable, potentially causing damage. |
6)Â HELMET MOUNT - Battery Installation: Run cord through helmet opening, attach extension cable, then attach to battery. NOTE: DO NOT ATTACH BATTERY TO HELMET.
Dinotte Lighting 1 Merrill Industrial Drive  Suite 10  Hampton NH 03842  www.dinottelighting.com