Version 1 Install Diagram

Version 1 Device

Installer PORTAL : https://moovetrax.com/installer-login

Installers will use this link to test ALL functions after install.

This link also keeps you in our database for future installs.

( GPS ID is found under the gps and also on the box)

Moove Trax GPS.

This is a GPS system which has remote functions like.

Lock Door. (trigger inside button)

Unlock Door.

Kill Switch.

Panic Button.

All output provides -ve pulse of 100ma max. We provide a quad relay with its wiring diagram on the next page.

Devices must be hidden but must be possible for the customer to reach and do things like replacing the sim card.

1 Yellow Wire is for constant 12V+. (tell the client which FUSE to remove if they want to restart the device)

2 Purple wire is for Smoke detection. (optional)

3 Ground Wire

4 Red ACC power 12V+. 12V will be sent to this wire when the car is in ACC or running.

5 Green. This wire should control a relay which will disable the Starter. This is a CONSTANT -ve and NOT a pulse. Only works with ACC on

6 Black Wire for 2nd ground.

7 White. This wire will detect when a door is open. This wire should be grounded to indicate the door is open.

8 Pink. This wire is for a panic signal it will issue Five 12V GROUND (-ve) pulses with 1 second between them.

9 Blue. This wire issues GROUND (-ve) for 1 second to be used to trigger the door actuator. - LOCK ( Trigger interior lock button)

10 Orange. This wire issues GROUND (-ve) for 1 seconds to be used to trigger the door actuator. - Disarm (ensure door unlocks) - double pulse can be set by editing device from webpage.

We now ship out our devices with a relay pack.

Our relay pack is usually already set to accept a ground pulse, In some cases you may have to move the jumper.

Relayboard is included for convenience, you may use your own relays if you wish.

Included Velcro is for protecting the underside of the Relay Board

ENSURE THE RELAY PACK WHITE LABEL IS NOT UPSIDE DOWN COMPARED TO THIS PICTURE.

Relayboard needs to be powered up separately, black is ground.

FEED will be what the wire requires to activate, some functions need a ground while others need a +12v.

Newer relays come with one more function after “Horn”, the function name is “Light”

Light gets triggered together with “Horn”.

Do not stick the antenna on glass as glass gets hot to the point the adhesive gets loose.

Installer Portal

https://moovetrax.com/installer-login

Once all functions work, Please invite the car owner by entering their email on the bottom of the page and clicking Invite

All signals are Analog, if the car is sending a digital unlock and lock, run the wires directly to the actuator or use a DB3 Module.

Install sim in device before you power up.

* Lock should be wired to the inside door lock button, this way a keyless key fob on the interior would not interfere.

** Unlock should be wired to the factory alarm disarm wire, this way there is no issue when the BCM goes to sleep. If you can not wire to the factory disarm, wire to the unlock and during setup turn on “Cycle” in order to keep the BCM awake.

PLEASE ENSURE ALL FUNCTIONS WORK BEFORE Delivering THE CAR, IF ALL FUNCTIONS DO NOT WORK, PLEASE CALL MOOVETRAX AT 202-979-TRAX

Tesla install

Relay Green wire goes to MooveTrax Green Wire.

Relay Yellow wire goes to Lighter blue wire +12V

Relay black with pin goes to black wire which was removed from connector.

Relay black with no pin goes to the connector.

GPS yellow wire goes to connector yellow.

GPS black goes to cig lighter black wire (ground).

GPS red wire goes to cig lighter yellow wire.