Zso’s Free Perm Unban Spoofer Tutorial
STEP 1: FLASH BIOS -
You will need to flash your bios. Make sure you do not stay on the same version, you must upgrade or downgrade. Use the links below to find a video tutorial on how to flash for your motherboard. To find your motherboard brand, open ‘Run’ by pressing ‘Windows’ + ‘R’, when the ‘Run’ window is open, type ‘msinfo32’ and then press ‘Enter’. Your motherboard information should be specified next to ‘Baseboard Manufacturer’ and ‘Baseboard Product’. If you cannot find your motherboard information, then you may skip this step.
IMPORTANT: If you have an active/premade RAID Array, you should have a Windows 10 USB (With Raid Drivers) ready before flashing your bios, incase of array corruption. You should also switch back to RAID mode after you flash otherwise windows will not boot.
STEP 2: CREATE WINDOWS INSTALLATION
After successfully flashing your bios, create a Windows 10 USB Installer with RAID Drivers.
First start with creating a Windows 10 USB and then after put the RAID Drivers onto the USB as seen below. Please make sure you put the correct RAID Drivers onto your USB for your CPU.
Tutorial for creating a Windows 10 USB
STEP 3: DISABLE TPM
This will disable the TPM Chip on your motherboard. If you have a pin on your PC, please disable it before turning off TPM. Follow the videos below to find out how to disable TPM for your motherboard.
STEP 4: REINSTALL WINDOWS
Please boot into your USB so you can install windows onto your fresh RAID Drive. Please follow the images below to correctly load the RAID Drivers.
Select [Custom: Install Windows Only]
Select [Loader Driver]
Go to your USB and select the folder you extracted containing your RAID Drivers. Select either NVME or SATA depending on your motherboard. (If you do not know, go for SATA.)
Now select the bottom driver and click next, then repeat the last step until you can
see your disk on the main menu.
When you see this, that means you have loaded all the drivers you needed and now you can install windows normally.
STEP 5: SETUP WINDOWS
Do not activate your windows licence. You must activate a different key or use the KMS method which can be found here.
STEP 6: DISABLE WIFI
After you have reinstalled windows, if you have a Wi-Fi adapter, you will need to permanently disable it, watch this video to find out how to.
If you do not have a Wi-Fi Adapter, you do not need to do this step.
We ask you to do this as it is impossible to spoof Wi-Fi MAC Addresses.
STEP 7: REMOVE EXTERNAL STORAGE
Remove all plugged in External Storage Hardware (USBs, External HDDs/SSDs).
Only use them when you are not playing and an anti-cheat is NOT running.
If you do not have any external storage, you can skip this step.
—----------------------------------------------------------------------------------------------------------------------------