Stainless Steel

E-Brake Handle

MINI F56

Overview

Thank you for purchasing the MINI F56 Stainless Steel E-Brake Handle from CravenSpeed.  The piece is made from the highest grade materials and is guaranteed to be free from defects.

Parts included are:

        1 ea Stainless Steel Handle

        1 ea ABS Collar

        3 ea O-Rings

        3 ea Set Screws

        1 ea 1/16 Hex Key

Procedure

1. Remove the factory e-brake handle. It is not glued on, but it will be snug. Grasp it firmly and pull off towards the button. It may help to torsionally twist it slightly back and forth during removal. If it’s being extra stubborn, spray a little WD40 inside (using the red tube on the can) between the handle and the button.

2. Take the CravenSpeed stainless steel e-brake handle and fit the included ABS collar on the e-brake boot end. It should just slip on over the flange on the end of the handle.

3. Slide the assembly onto the MINIs e-brake inner handle structure. The ABS collar has a ‘step’ on the end that will fit tightly into the plastic trim of the factory e-brake boot.

4. Ensure that the (3) threaded holes are facing up and insert the included set screws into the handle, tightening them with the included hex key.

5. Finish the install by rolling the included o-ring ‘grips’ onto the handle and into their respective grooves.

6.  You’re finished! Marvel at your handywork then go for a drive and enjoy your new shiny piece of kit!

If you have any questions about this installation, please give us a call at (503)505-6886 from Monday - Friday between 8am and 4:30pm Pacific Time and we will be glad to give you a hand.

We love pictures too! If you have some nice photos of our products that you would like to share with us you can email them to: support@cravenspeed.com