T A I L L I G H T   K I T :   P A R T S

Taillight-Kit-Instructions-Tall.png

Approx. Diameter Range:

(QTY: 1) …………………………………………..……………… Part No.:

Approx. Diameter Range:

(QTY: 2) …………………………………………..……………… Part No.:

Approx. Diameter Range:

(QTY: 2) …………………………………………..……………… Part No.:

Approx. Diameter Range:

(QTY: 1) …………………………………………..……………… Part No.:

Depth: 41mm (1.63in). Approx. Width Range:

(QTY: 1) …………………………………………..……………… Part No.:

Approx. Diameter Range:

(QTY: 1) …………………………………………..……………… Part No.:

Approx. Diameter Range:

(QTY: 1) …………………………………………..……………… Part No.:

Approx. Diameter Range:

(QTY: 1) …………………………………………..……………… Part No.:

(QTY: 2\) …………………………………………..……………… Part No.:

30mm - 35mm

B-7

27mm - 30mm

B-4

21mm - 27mm

NB-3

16mm - 21mm

B-2

14mm - 19mm

Aero Post

14mm - 18mm

B-1 (19)

14mm - 18mm

B-1 (15.8)

14mm - 18mm

B-1 (12.7)

Foot (not marked)


H E A D L I G H T   K I T :   P A R T S


DiNotte Lighting    1 Merrill Drive  Suite 10  Hampton NH 03842  www.dinottelighting.com

H E A D L I G H T and T A I L L I G H T   K I T :   I N S T A L L A T I O N

1) Select clamp and rubber rubber strip for spacing and friction.   Insert rubber strip into clamp. Always use a rubber strip.

2) Line up the end of the rubber strip with the edge of the clamp. Cut off the excess rubber.

Use thin strip for friction if no strip is necessary. 

3) Mount the clamp on the seatpost (with the longer edge on the left side of the bike) and screw the clamp.

4) Install the Foot UPRIGHT/POINTING UP (NOT down) using screw, and do not tighten completely.

5) Slide Taillight onto the Foot until you hear the Quick Release click into place. Adjust Taillight to desired angle (about 90° angle from the ground, or slightly pointing down towards the ground, is recommended). Tighten the screw holding the Foot to the Clamp mount. (Optionally, mount on Seatstay).

(NOTE: 300R shown, but all of the following models mount identically: 300R, 400R, DAYTIME RED, DAYTIME AMBER, 400L).

Always listen for the quick release to click in.  If it does not click in, remove light, depress tab on quick release and re-install

6) OPTIONAL BOLT ON MOUNT: To permanently mount taillight unscrew the Quick Release plate. Insert Shoulder Washers (black) into Foot, then insert screws and fasten to taillight as shown below.

(NOTE: 400R shown, but all of the following models mount identically: 300R, 400R, DAYTIME RED, DAYTIME AMBER).

DiNotte Lighting    1 Merrill Drive  Suite 10  Hampton NH 03842  www.dinottelighting.com