SPARKELECTRONICS

The magnetic sensor

Installation instructions


The magnetic sensor

Installation instructions

Description ofDevice

Application

Property

Mounting Instructions

Technical and operational


Description ofDevice

Application

sensor is designed to provide the speed signal from the magnet placed on the rotating element, reflecting the speed of the vehicle.  

Property

is built depending on the version:

sensors depending on the version may have 3PIN connector M8 female connector or cable without the connector.

Mounting Instructions

Attach the sensor to the front or the side plane was close to the magnet rotating on the element, a distance between 2-10 mm. The distance between the face of the sensor and the magnet Adjust so that the rotating element and the sensor did not break speed pulses were acquired without interruption.

Magnets attach to the rotating element with glue or plastic ties and then secure it with putty contained in a set of magnets (kit should knead with your fingers about 1 minutes and then obkleić magnets. After 10 -15 minutes, the mass reaches the hardness of metal)

can also protect the magnets another method.

magnets mounted on the drive shaft, taped self vulcanizing.

czyjnik_magn_monta_polos_3.jpg

Universal sensor mounted on a bracket

czyjnik_magn_monta_polos_5.jpg

Connect the sensor to the tripmeter according to the diagram.

 20140304_schemat_podlaczenia_en.jpg

To check and adjust the operation of the sensor, betwen sensor signal cables connect the multimeter in the "BIP". Each pass of the magnet next to the sensor should cause activation signal "BIP" on the meter.

Connect the sensor to the tripmeter according to the diagram. Set odometer pulse measurement mode and calibrate. Please note that:

Technical and operational