3 0 0 R    T A I L L I G H T    O P E R A T I N G    I N S T R U C T I O N S

Charge battery fully before initial use.

Charge indicator will be RED while battery is charging.

Charge indicator will turn GREEN once battery has finished charging.

Charge Time: 4 Hours.  Charger Operating Voltage: +5 V. Weight:  120g

Power: ON and OFF

  • ON: Double press the power button.
  • OFF: Press and hold the power button for two seconds.

Note: Release the button as soon as the light turns off, or you may accidentally change the modes. The light will always turn on in the last mode used.

Low Battery Indication

The light will strobe briefly indicating approximately

20% of battery capacity remains.

Choosing the light mode (Steady or Flash)

Note:  Please check local laws, as Flash modes are not legal in many areas.

If you wish to change the mode of the light from Steady to Flash, or Flash to Steady:

  • WITH THE POWER OFF, press and hold the power button for six seconds, light will visually indicate a change of mode.
  • RELEASE power button when change is indicated.
  • Double-click to turn light on. The light should be in the new mode.

Note:  When turning off the light, release the power button as soon as the light turns off.  Continued holding may accidentally change the mode.

Understanding the light modes:  Steady mode and Flash mode

The 3 Steady modes are:

100% power (100% light output) ................4 hour run time

50% power  (65% light output) ..................8 hour run time

25% power (33% light output) ..................16 hour run time

Single press power button to toggle between power modes, while light is on.

The 3 Flash modes are:

Slow Pulse ..................36 Hour run time

Rapid Pulse ..................12 Hours

Strobe ..................12 Hours

Single press power button to toggle between power modes, while light is on.

Note:  Please check local laws, as Flash modes are not legal in many areas.

Troubleshooting:

Problem: Light won’t turn on because power button is stuck (due to vacuum).

Solution: Unscrew front screws and slightly lift front plate, and the button will pop back out. Screw screws back in (See below)

Dinotte Lighting    1 Merrill Drive  Suite 10  Hampton NH 03842  www.dinottelighting.com