Photo Camera Datasheet

Spring, 2016

Overview

The photo camera accessory connects to the Syrus via (RS-232) serial port (RX & TX cables) and takes photos based on any configurable event conditions.  The camera is fully integrated with the Pegasus Gateway and its APIs allowing you to take low, medium, or high resolution photos based on multiple conditions.

Features

Technical Specifications

Sensor

Resolution

640x480px / 320x240px / 160x120px

Power Supply

DC+5V, 9-36V

Focal Distance

2.0mm, 2.8mm, 3.6mm, 12.0mm

Baud Rate

115,200bps

Serial Interface

RS232/RS485/TTL

Infrared

Infrared Light

Night Vision Distance

3-20 meters

Image Sensor

CMOS OV7725

Cable Length

4 meters

Connector

DB9 (RS-232)

Operation Temperature

-20  -  85ºC

Operation Humidity

20-80%RH

Material

Waterproof IP67 Metal Case

Minimum Lumens

1 Lux

Night Vision Lumens

5 Lux

White Balance

Automatic

Exposure

Automatic

Auto Gain Control

Automatic

Other

Anti-Shake, Anti-interference

Dimensions


Installation Tips

It is recommended to use a “surge” protection for the power of the camera accessory, as sometimes transient voltages found in vehicle’s can cause permanent damage to the camera.

An example of a surge protection: Transient Voltage Surge Protection

Installation on Syrus3G

Follow the pinout guide below and connect all cables of the serial camera and to Syrus’ power wire and to the serial cables as follow:

Pinout

  Syrus Cables

Green

Main Power

12V-24V

This cable provides same power as the Red cable Main Power. Connect it to the Camera’s main power cable (RED)

Brown

Ground

0V

Pin 16 on Syrus 2 devices – must be connected to the Syrus GND

Orange

TX

Transmit Data

Must be connected to the camera’s Green cable (in the serial port)

Purple

RX

Receive Data

Must be connected to the camera’s Yellow cable (in the serial port)

 

  Camera Cables

Red

Main Power

12V

Must be connected to the Syrus main power cable (green – pin #7)

Black

Ground

0V

Must be connected to the Syrus GND (black – pin #16)

Green

RX

Receive Data

Must be connected to the Syrus’ Orange cable

Yellow

TX

Transmit Data

Must be connected to the Syrus’ Purple cable


Installation on Syrus 2G

Follow the same process for Syrus3G above for power and ground connection cables and just connect the serial camera cable to Syrus 2G serial port:

Photos

Low Resolution

Approx. 2KB to 4KB

Medium Resolution

Approx. 5KB to 15KB


High Resolution

Approx. 15KB to 30KB

FAQ

v1.0 . www.digitalcomtech.com

5835 Blue Lagoon Drive Suite 202 . Miami, FL 33126 . (305) 809-0638