T3P3 Kossel Mini Kit Release 3

Assembly Instructions

Chapter 10 - Endstop Wiring

Creative Commons License

This work is licensed under a Creative Commons Attribution-ShareAlike 4.0 International License.

Think3DPrint3D Ltd

http://www.think3dprint3d.com/

  < Back      

> Forward

1001 Parts needed

Prepared X (red), Y (green) and Z (blue) endstop cables with labelled black Molex plugs on the controller end and insulated spade connectors on the endstop ends.

1002 Fit cables to endstops

Fit the spade connectors onto the outer terminals of each endstop.

Loosen the M4 dome head socket

screw . . .

. . . and slide the endstops up until they are about 8mm below the undersides of the top brackets and not quite touching the belt tensioner bolt ends. Try to get them all as close to the same level as you can. Tighten the  M4 dome head socket screws to fix them in place.

1003 Secure endstop cables

Route the endstop cables around the towers and into the channel on the outer face of each tower. Ziptie in place.

Tighten the X and Y endstop cables and ziptie at the bottom of the towers.

The Z endstop cable has to bypass the extruder so can’t yet be fixed at the bottom of the tower.

Now go on to the next Chapter.

  < Back      

> Forward