X P L - 3   H E A D L I G H T  I N S T A L L A T I O N  (XML-3 shown)

1) Wrap adhesive rubber strip (in box) around mounting location of handlebar if handlebars are slippery.  Unfasten and open strap. Place XPL-3 on handlebar with one hand as shown.  

2) Feed strap up through slot. (Be sure strap is only going around handlebar, not brake or shifter cables!)

3) Tighten strap so the XPL-3 is secure.

NOTE: Always loupe strap up through slot and then pull down.

4) Fasten by pulling down and lock it into place.

Never go straight up without going up through slot first.

5) HELMET MOUNT (optional)  - Headlight Installation: Repeat the same steps for the helmet mount:

    If the XPL-3 does not stay in place on the handlebars, it is a friction issue.  Please use adhesive strip included.  Attach Strip directly to handlebars.

(NOTE: XML-3 shown, but all of the following models mount identically: XPL-3, XML-3, XML-4).

 DiNotte Lighting

XPL-3 User Manual

Power ON and OFF                                                Specifications  (XPL-3)

ON:  Double press power button                                        Light output: 1200 Lumens

OFF:  Press and hold power button for two seconds                Light engine weight: 190g 

Note:  release power button when light turns off.                                 Dimensions: L-85mm x 40mm Diameter

See switching between flash/steady modes to change modes

                                                                                

                                                                         

Power indicator: (power button color)                                

Blue - normal power operation                                        

Red - low battery mode - change or charge batteries as soon as possible.

When light is ON, single press power button to change between high, medium and low modes.

Steady modes (3)                                               Flash modes (3)

High:  full power output.            1200 Lumens                        High:  light pulses rapidly with solid

blue power indicator.                                         background.  Blue power indicator

                                                

            Medium:  50% power, blue power indicator                              Medium:  steady light with pulse

            pulse once per second.   800 Lumens                        Blue power indicator with one blue pulse per

second.

           Low:  25% power, blue indicator with                          Low:  light slowly turns on and off.  Blue

           two blue pulses per second.  400 Lumens                        power indicator with two blue pulses per second.

Low battery:  Red indicator, light will be forced into ultra low mode

During low battery, switch may become inoperable.

Switching between FLASH and STEADY modes:  (start with light in the OFF Mode)

Press power button for approximately six seconds (front light will signal it has changed modes)

Release power button, wait one second.

Double press power button to turn on light.  New mode will be active.

Battery Charging:

Plug charger into wall, wait 10 seconds for charger to warm up.

Attach battery to charger.  When indicator is RED, charge is in process.  

Charge indicator will turn blue when charge is complete.

        

Run times are approximate and only apply to single, continuous use.

                                XPL-3

 2 Hour charge time

 240gm, 7.2V 4400mAh

                                Steady                Flash

        High                1.5 hours        5 hours

        Medium              3 hours        6 hours

        Low                  6 hours        8 hours

_

.

Dinotte Lighting    1 Merrill Drive  Suite 10  Hampton NH 03842  www.dinottelighting.com