Q U A D R E D, AMBER and White Mounting Kit

400R and Daytime Red Mounting Kit

Clamp List

Approx. Diameter Range:

(QTY: 1) …………………………………………..……………… Part No.:

Approx. Diameter Range:

(QTY: 1) …………………………………………..……………… Part No.:

Approx. Diameter Range:

(QTY: 1) …………………………………………..……………… Part No.:

30mm - 35mm

B-7

27mm - 30mm

B-4

21mm - 27mm

NB-3

Foot (not marked)

2 Rubber Strips and Screws also included for mounting.

Smaller and aero clamps are also available by request.

dinotteservice@gmail.com

I N S T A L L A T I O N

(quad red shown with quick release - 400R and Daytime Red are hard mounted)

1) Select clamp and rubber rubber strip for spacing and friction. Insert rubber strip into clamp. Always use a rubber strip.

2) Line up the end of the rubber strip with the edge of the clamp. Cut off the excess rubber.

Use thin strip for friction if no strip is necessary.

3) Mount the clamp on the seatpost (with the longer edge on the left side of the bike) and screw the clamp.

4) Install the Foot UPRIGHT/POINTING UP (NOT down) using screw, and do not tighten completely.

5) Slide Taillight onto the Foot until you hear the Quick Release click into place. Adjust Taillight to desired angle (about 90° angle from the ground, or slightly pointing down towards the ground, is recommended). Tighten the screw holding the Foot to the Clamp mount. (Optionally, mount on Seatstay).

(NOTE: Quad RED shown, but all of the following models mount identically: 300R, 400R, DAYTIME RED, DAYTIME AMBER, 400L).

Always listen for the quick release to click in. If it does not click in, remove light, depress tab on quick release and re-install.

•

DiNotte Lighting 1 Merrill Drive Suite 10 Hampton NH 03842 www.dinottelighting.com

dinotteservice@gmail.com