2014-2016* Jeep Grand Cherokee SRT Headlight DRL Activation Kit

Features

• Headlight DRL LED Ribbons activate to full intensity in ‘Run’ ignition position

• Headlight DRL LED Ribbons dim automatically when headlights or parking lights turned on (installer selectable)

• Posi-Tap connectors included for splice-free connection for reversible installation.

• Secure Ground connection using ring connector

• All connections Soldered

Wiring Colors:

*March '14+ builds & 2015 models - Adding missing DRL Lamp wire: http://youtu.be/yuCF_gTu6Eo*

**Proceed with installation and use at your own risk. Not liable for Damage**

Installation

1) Ensure vehicle ignition , parking lights, and headlights are in the ‘Off’ position

2) Remove DRL Fuse from Fuse box position F40 (10 amp), Align the Fuse tap with fuse and reinsert into fuse position with fuse tap facing front of vehicle.

3) Run wire attached to Fuse tap out of the Fuse box where the positive red battery post is  connected and close fuse box.

4) Connect ground terminal to Ground Jumper post by unscrewing jumper post and sliding ring connector over threaded bolt. Re-install Ground Jumper post to secure ground connection.

5) Unplug passenger headlight wiring harness

6) Strip back factory wire loom to expose at least 6” of wire.

7) Using Posi-Tap connectors, make below connections

        Passenger DRL→ White w/Dark Blue Stripe ( harness position 3)

        Passenger Low Beam→ White w/Orange Stripe ( harness position 1)

        ***optional - if you would like Headlamp DRL LED Ribbons to dim with parking lights connect passenger Low Beam wire to -->White w/Orange Stripe (harness position 6)***

8) Route remaining wire loom across front of engine bay ( see Fig. 3)

9) Unplug Drivers Side HEadlight Harness

10) Strip back factory wire loom to expose at least 6” of wire.

11) Using Posi-Tap connectors, make below connections

        Driver Side DRL→ White w/Yellow Stripe ( harness position 3)

Using Posi-Tap Connectors

Wiring Diagram:

**Proceed with installation and use at your own risk. Not liable for Damage**

*March '14+ builds & 2015 models - Adding missing DRL Lamp wire:

Passenger / Fuse Box Side

Driver / Intake Side