RC HELICOPTER USING INSTRUCTION

3.5-CHANNEL G.YRO SYSTEM

To avoid copters damage and players injury, please read this instruction before flying!

Safety regulations

1. Placed in small parts of the reach of children, to avoid accidents. 2. The blades of this helicopter is used activities blades,dont screw up. 3. The helicopter was powerful, should be gradually pushed up the remote control shift lever on the left for first flight, to avoid the surge caused the helicopter crash damage. 4. Should be turn off the power of controller first then turn off the power of the helicopter

when finished flight. 5. Do not place the battery in high temperature, heating placee.gfire or electric heating

devices) . Note that when the helicopter to keep the user or other persons from 2-3 m to avoid the

helicopter flight, landing crashed into another persons head, face and body and so on. 7. Children should control the helicopter by adults in the guidance and ensure the helicopter

control in manipulator (or guides) line of sight range, easy to control. 8. Non-rechargeable battery is not charging,installation the lithium battery, please note that

the battery polarity. Do not mix old batteries and new batteries or different type batteries. . Should be turn off the power of the controller and helicopter when not in use. 10. Power terminal is not allow short circuiting.

Ready to fly

1. Please recheck the ground, keep away from the crowds, animals and other barriers. 2. Turn the remote control on, after a while, the LEDs will be flashing. Push the motive handle must

be pushed to the maximum control route of travel first, then adjust it to the lowest; When the remote control LEDs keep lighting, it means the helicopter is going to fly. 3. Move Power Swithch on the helicopter the the ONposition, after that, the power indicator will

light up; Place the helicopter on the ground for some seconds,then the helicopter is going to fly. 4. Push the motive handle slowly, then the helicopter will fly up.

Low volatage protection

Low volatage protection: When the helicopter power is weak, helicopter control system will protect the

battery and the power supply to the helicopter blades will be stopped. After low volatage protection, it can fly again if the helicopter charged.

Maintenance

1. Cleaning the helicopter with clean and soft cloth.

2. Dont put the helicopter under the direct sun or strong lighting

. Dont soak the toys in the water, or the electronic parts will be destructed.

4. Regularly check the plug and other spare parts, if find some parts broken, please stopping

using till the product in good condition.

Assembly transmitter & helicopter charging

Assembly transmitter

Battery cover

1. Install antenna: Install the antenna in the transmitter by turning it clockwise until finger tight. 2. Install batteries: Open the cover of battery case, insert 4 batteries (size 1.AA) properly followed

by polar indicator. (batteries to be purchased)

1. Install batteries carefully. 2. Do not mix old and new batteries. 3. Do not mix different types of batteries.

BatteryHelicopter

W While charge pull out the switch 110wzzow of the helicopter to OFFposition up.

OFF m) -

Always turn off the helicopter power, connect the charge plug of the charger to the charge slot on the helicopter, then insert the charger into the power jack. When charging, charger LED lights from green to red said recharging; When LED lights from red to green, indicating charging finish. Helicopter charging time about 80 minutes, the flight time about 8 minutes.

Charging time can be 80 minutes flying about -8 minutes.

- Helicopter is equipped with a LiPoly battery, please also pay attention to the following cautions or

safety use.

- Do not use or leave the battery near a heat source such as fire or heater. Otherwise it will cause

damage or explode.

- Do not use the battery slam or beating hard surface.

- Do not immerse the battery in water, and keep the battery in a cool dry place.

- Charger included with the product can only be used for the product charge.

- Do not disassemble the battery.

- Never leave the battery unattended during charging.

Helicopter control ways

counter clockwise.

Push the rudder Stick toward left to turn

When you push down the right control lever

(steering rudder, the nose incline helicopter is moving to backward.

to up, the

When you push up the right control lever (steering rudder, the nose incline to down, helicopter is moving to forward.

the

Push the rudder stick toward right to turn clockwise.

Ascend

When you push up the left stick (throttle) the speed of the main rotor blade will increase and the helicopter will go up.

-بع

AB frequency switching

when in the same Descend frequency can

imultaneously flying A When you pull down the left Frequency and P

stick (throttle) the speed of the main rotor blade will decrease

frequency, both helicopters can be play individually.

Toggle button

The helicopter has two

flight modes, for beginner

and for Masterhand:

1. Beginner mode

(Factory default state)

2. Masterhand mode

Once press the switch which is on the right bottom of the remote control, then the helicopter will change into the Masterhand mode.

and the helicopter will go down.

Rotates Clockwise

When the helicopter tail presents the clockwise rotation, you may the counterclockwise rotation you in the hand the remote control vernier adjustment knob until balanced.

Rotates . . Anticlockwise )

When the helicopter tail presents the counterclockwise rotation, you may the clockwise rotation you in the hand the remote control vernier adjustment knob until balanced. The tail fin aim at the operator.

Maintenance program

Problem Cause

Check this

1. Not enough power for the helicoper. No reaction 2. Not enough power for the controller.

3. The channel was different from helicopter and the

1. Should be charging for the helicopter. 2. Change new batteries instead. 3. Make sure the same channel from helicopter and

when was fly

from the controller. the controller. helicopter . The gyro of the helicopter cant find out the right . Move the helicopter onto the flat ground, when

point. the gyro receive the signal,then open the controller.

Not reaction - - - - - - - - - - - - - from the 1. By sunlight or intense light irradiation effects. 1. Move the helicopter onto without sunlight or

- 2. Have the same frequency remote control intense light. helicopter transmitter. 2. Not the same for a launch interference.

Spare parts list

Order by item number from local distributors.

Graphic detail

Lem Number Description QyNeed

Balance bar

02 Connect buckle

03 Inner shaft

04 Upperblades grip set

05 Upper blades

06 Stainless steel tube

LOWerblades grip set

08 LOWerblades

09 Motor cover

10 Motor A

11 Motor B

12 Main frame

13 Upper aluminum sheetsight)

14 figHI)

15 Upper aluminumsheetef)

16 LOWeraluminumsheetef)

17 LOWr blades gear

18 Transition gear

19 Upper blades gear

20 Die Copperset limit

21 Battery case

22 Battery

23 PCB

24 Chassis

25 Landing skids

26 Head COVer

27 Right tail tube

28 Left tail tube

29 Tail aluminium tube

30 Light

31 VerticCalfin

LemNumber

Description

Horizontal tail

Tail blade

Tail rotor rack

CyNeed

安全守则

1.清將直升杭寂小零部件放置干小孩不能觸及的地方,避免友生意外。 2,本直升机风叶均采用活动风叶,切勿将其控紧。 3,,,避免

直升杭急速上升而早致碰撞損切林。 ,飞行结束后,应先关闭遥控器电源,再走近直升机关闭飞机电源。 ,切勿将电池放在高温、受热的地方如火中或电热装置附近。 .注意直升机飞行时与使用者或其他人保持2-3米的距离,避免直升机飞行、

降落时撞向他人的头部、脸部或身体等。 .儿童操控直升机时应由成年人在旁指导并确保直升机控制在操纵者

(或指导者)的视线范围内,方便控制。 .非充电电池不可充电,安装或更换电池时请注意极性;不可混用新旧或不同

类型的电池。 .不使用时应关闭遥控器及直升机电源,并取出遥控器内的电池。 10. 申源端子不得短路。

,常用干净软布清洁此产品。

,避免此产品在阳光下暴晒或受热。 ,切勿将些玩具浸在水中,否则会令电子粤件受损。定期检查插头及其它配件,如发现任何损坏,请马上停止使用,直到完全修复。

3匣清勾混合使用不同种类的电池。

直升机电池充电

先关闭直升机电源开关,把充电器上的充电插头连接到直升机的充电槽,然后将充电器插入电源座中。当充电时,充电器LED灯由绿色转为红色,表示正在充电当LED灯由红色转为绿色,表示已充电完成。

充电时间为80分钟,飞行时间约78分钟。